This is a reasonable job,but care needed to not break plastic parts.The instrument binnacle is held in by two bolts only but to access them you have to remove the "mixed air nozzles"either side.This can be done by prising with plastic wedges.Think the rotary light switch has to be removed,ease it out set to side lamps and undo a screw.The indicator and wiper switches have to be removed for clearance after removing their covers.Once instruments are unbolted,ease towards centre and release the wiring plug.Good luck.
Probably.
remove trim around clocks, remove clocks, replace bulb in back. hope this helps
The bulb failure lamp on a 1999 Opel Vectra B?æis located on the dash board. It is an operational amplifier chip.
yea as long as the stud patten is the same which i an sure it is
What is the name of my great uncle?
diagram of where crank shaft sensor goes on vauxhall vectra 2.o sri 1999 model
My vectra is a 1999 S plate and has a factory fitted immobilizer, I think that alarm/ immobilisers were fitted as standard the year after mine.
they are 2 totally different mdels. Vectra B is from 1995 till 2002, and was upgraded in 1999. Vectra C/Signum is the latest model from 2002 till 2008, and then you of course the newest Vectra D introduced early tis year.
Answer this question...pop driveshaft out bud
140 + If driven by right person
16. 6 in the engine and 10 in the radio
pull out the fins of the air vents and the screws are hidden behind. from there the dash should just pull out but be careful as it is very tight and i scratched hell out surrounds removing the clocks Also you need to lower the steering wheel as low as possible, as to screws to the console are at the rear of the column