answersLogoWhite

0

You shouldn't have to worry about it. With the engine still cold, just let it idle in the drive way with the expansion tank cap off. Eventually, the car will cycle the coolant and the air will exchange places with whatever coolant is in the expansion tank. Then top off the expansion tank, let it idle a little longer and see if the level gets any lower.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

98 Nissan Quest Your heater runs cold at idle hot at 55 Thermostat was replaced HELP?

you may have trapped air in the cooling system..try bleeding the cooling system


98 vw beetle air and fan wont turn on?

Replace the climate control/fan circuit fuse.


Where can you get a diagram of the 98 Ford Taurus cooling system?

The cooling system helps keep the car from running too hot. A diagram for the 1998 Ford Taurus cooling system can be found in the car's maintenance or repair manual.


How do you bleed the air out of the cooling system after replacing the radiator on a 98 Honda civic ex?

The cooling system is bled using the bleeder screw found on the thermostat housing. To find the thermostat housing on a 1998 Honda Civic follow the lower radiator hose to its outlet. While the cooling system is running loosen the bleed valve. When bubbles stop coming out the system has been bled.


What is the problem if the cooling fan not turn on in 98 Honda CR-V?

If the engine cooling system fan, check the fuse/relay to see if the it has blown out. If not the fuse/relay, the cooling system temperature sensor switch may have failed. For he A/C system auxiliary cooling fan, the same trouble-shooting method. If you are referring to the cabin interior circulating air fan - check the fuse and/or the switch that controls the fan speed.


Where is the 98 beetle rear defroster fuse located?

On the 98 Beetle, the rear defroster fuse is located under the dash. It is found in the number eight slot.


What year did the remake the VW beetle?

They remade the '66VW Beetle in '98.See:http://www.superbeetles.com/history.htm


Where do you put the coolant on a 98 Malibu 3.1?

any service on cooling system is through the recovery tank for radiator.


How do you bleed air from the cooling system of a 98 Acura 1.6 EL?

It is difficult to remove the trapped air from some cooling systems, there is a special funnel that helps do this, at DenLors Tools there is a Tech Article that goes into detail and there is a short video showing the use of the funnel, see the link below or go to DenLors Tools an check out the Tech Article section.


Where can you find a diagram of the cooling system to a 98 Pontiac grand am?

A person can find a diagram of a 1998 Pontiac Grand AM cooling system in the cars maintenance manual. They can also ask a person at an auto part store for a print of the diagram.


Where is the bleeder for cooling system for a 98 Cadillac Catera?

The bleeder valve for the cooling system on a 1998 Cadillac Catera is located on the coolant crossover pipe, which is situated at the front of the engine, near the thermostat housing. To bleed the system, you should run the engine until it reaches operating temperature, then open the bleeder valve to release any trapped air. Ensure the coolant level is topped off during this process to prevent air from re-entering the system. Always exercise caution when working with hot engine components.


How much does it cost to replace pads and rotors on a 2003 vw beetle?

I paid 400 for my 98' vw beetle. Did I get ripped off?