0
What else can I help you with?
What is the right tire pressure for a 91 Mercedes 500sl convertable?
I have a 1990 Mercedes 500sl and there is a suggested tire pressure sticker located on the inside of the fuel door.
How do you remove the hardtop on a 1990 Mercedes 500sl?
put it on the top of one of those big lorries that deliver vehicles. then drive under a low bridge.
How do you release the locks on a 1990 Mercedes 500sl hardtop manually?
To manually release the locks on a 1990 Mercedes 500SL hardtop, locate the release mechanism inside the trunk. You may need to remove the trunk liner to access the locking mechanism. Once exposed, use a flat-head screwdriver or a similar tool to disengage the lock manually. Always ensure the car is in a safe position and consult the owner's manual for specific instructions related to your vehicle.
What size tool do you need to take off the drain plug for the differential on a 1990 Mercedes Benz 500sl?
To remove the drain plug for the differential on a 1990 Mercedes Benz 500SL, you typically need a 14mm hex (Allen) wrench or socket. It's advisable to check the condition of the plug and the surrounding area for corrosion before attempting to remove it. Using the correct size tool will help prevent stripping the plug. Always ensure the vehicle is safely supported before performing any maintenance.
Where is the afm sensor on 1990 Chevy S-10?
how do you install a 1994 Chevy prism ignition
where can i find a air flow sensor for a 1990 300e benz 3.0?
You can buy it online here: http://www.drivewire.com/vehicle/mercedes-300e/mass-air-flow-sensor/
Online owners manual for a 1990 Mercedes 300 E?
How do you open the hood on a 1990 mercedes
How do you change a speed sensor on a 1990 Oldmobile 98?
To change the speed sensor on a 1990 Oldsmobile 98, first, disconnect the battery to ensure safety. Locate the speed sensor, which is typically found on the transmission. Remove the electrical connector and unscrew the sensor using a socket or wrench. Install the new sensor by reversing the removal process, ensuring it’s securely fastened and reconnect the battery.
How do you replace the RABS sensor in a 1990 Ford Bronco?
To replace the RABS (Rear Anti-lock Brake System) sensor in a 1990 Ford Bronco, first, ensure the vehicle is safely lifted and secured. Locate the sensor, which is typically mounted on the rear axle or differential. Disconnect the electrical connector and remove the mounting bolt to take out the old sensor. Install the new sensor by reversing the process, ensuring a tight fit and reconnecting the electrical connector.
Where are speed sensor on 1990 supra?
The 1990 Toyota speed sensor is located on the back of the transmission. There also is a speed sensor on the front passenger wheel.
Where is the crank position sensor on 1990 Dodge Dakota 3.9L?
No crank sensor on a 1990, only the pickup plate (cam sensor) in the distributor. how about a 1991?
What is a map sensor on a 1990 cutlas and were is it?
if it has a 3.3 there is no map sensor
