0
Unscrew the air filter cover. The mass air flow sensor assembly is between the top of the air filter cover and the large rubber hose. Unscrew the clamp to the rubber hose. Unplug the sensor. (Mine had a wire tie clamped on the plug and I had to cut it off.)
Pull off the cover and turn it upside down. Inside the air fliter cover, in the middle, you will see 4 nuts that attach to the mass air flow sensor. Take a socket and unscrew them. You will see one nut in the corner. Unscrew it and the assembly will come off.
Take the new assembly and re-install.
What else can I help you with?
Why is my Mazda 323 sputtering?
your mass air flow sensor is outta wack or your oxygen sensor... your mass air flow sensor is outta wack or your oxygen sensor...
Where is the intake air temperature sensor on 1995 Mazda mx3?
In mass air flow sensor.
Where is the Mass air flow sensor located on a 1989 suburban?
The 1989 did not use are even have a Mass air flow senser.
How do you fix the low rpm in a Mazda 323 89?
mass air flow sensor
How do you install a sensor?
The mass air flow sensor is installed between the intake of the engine and the air filter
How do you install a MAF sensor?
The mass air flow sensor is installed between the intake of the engine and the air filter
Why does my 1989 camaro have a code 34?
mass air flow sensor or manifold pressure sensor. your car will have either or.
Where is the intake air temp sensor located on a 2007 Mazda 3?
The intake air temperature sensor is located on the mass air flow sensor on the intake. There are five wires attached to the sensor.
Where is MAF sensor on Mazda 626 1996?
AnswerIt is built into your Mass Air flow sensor so you have to replace the whole thing, for the 98 and up they are separate.
Can you install a mass air flow sensor on c220?
yes, but in certain ways like positioning..
How do you change the oxygen flow sensor on a Chevy Malibu?
Very simple. Unplug the wire to the sensor, unscrew/remove the sensor, install new sensor and plug it in. You're done. Have fun.
How do you install intake for Mazda Protege 5?
Disconnect the battery Unclip the intake box where the filter goes and remove the sensors on it Mas air flow sensor (the one with the big square on top) and the IAT Sensor (Little one connected to the side of the intake box). Unscrew the box under it that has the filter and remove. Remove the tubing that connects to the throttle body. Install the new intake to the throttle body Install the MAF sensor a the end of the half tubing Install the other half after it Install the IAT sensor at the whole that it has for it Install the filter that came with the new intake Reconnect the battery and let the car run for a bit make sure all the connections are re connected
