answersLogoWhite

0

disconnect the battery, wait 5 min (airbag thing) insert a flat blade screwdriver into the hole at the bottom of the steering wheel and press, this should allow the airbag to be pulled out and disconnected

which hole?diagram possible?

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How would you remove a starter motor on a Peugeot 406 LX DT?

how do youremove a starter moto on a peugeot 406 please


Where are the headlight fuses in a Peugeot 406?

lift steering wheel height adjuster lever and undo 3 plastic screws 1/4 turn. cover is hinged and will drop open.


Where is brake light switch for peugeot 406?

it says in manual that its behind the steering column only if its not a automatic


How do you remove a driveshaft off of a peugeot 406?

This is a complex procedure, get a manual for this vehicle.


How do you remove a fuel pump peugeot 406 2.0 lx petrol?

Slowly


How do you change the power steering belt on a peugeot 406 hdi?

To change the power steering belt on a Peugeot 406 HDi, first ensure the engine is cool and disconnect the battery. Remove any obstructions, such as the engine cover, and then locate the power steering pump. Loosen the tensioner bolt and adjust the tensioner to release the belt, then remove the old belt. Install the new belt by routing it around the pulleys, adjust the tensioner to apply proper tension, and finally reconnect any removed components and the battery.


Where the hom on the Peugeot 406 2.0hdi?

WHERE THE HOM ON THE peugeot 406 2.0hdi out sade


Diagram of front suspension on Peugeot 406?

were will i get information for 1996 peugeot 406 petrol


Where is the Peugeot 406 2.0 HDi diagnostic socket?

Ive just hunted this down for my own car and from what i can gather its behind the panel below the steering wheel although i havent checked yet i found this info in a forum


How do you change the ignition coils on a Peugeot 406?

How do you change the ignition coil on a peugeot 406 coupe?


How do you change ignition barrel on peugeot 406?

To change the ignition barrel on a Peugeot 406, first, disconnect the car battery to ensure safety. Remove the steering column covers by taking out the screws and carefully prying them apart. Then, insert the key into the ignition, turn it to the "ON" position, and press the release pin on the barrel to pull it out. Finally, install the new barrel by reversing the process, ensuring it locks into place securely before reassembling the steering column.


How do you replace a heater matrix on a Peugeot 406?

not an expensive job to do. part cost about £10 but apparently it is an awkard job as a part of the dash on passengers side needs removing to get in at it. how do you remove a heater motor from a peugeot 406 do you have to remove the full dashboard or just the glove compartment