To remove the speaker cover screen on a 1997 Mercedes S500, start by gently prying off the cover using a flathead screwdriver or a trim removal tool, taking care not to damage the surrounding trim. Look for any screws that may be securing the cover and remove them. Once all fasteners are removed, carefully pull the speaker cover screen away from the door panel. If needed, consult the vehicle's service manual for specific instructions related to your model.
Carefully remove the A pillar cover.. Then pop out the speaker screen..
After you take the speaker grille cover off, you can grab the edges of the speaker and pull it out. It's held in by metal spring clamps that are attached to the speaker. They just pull out and snap back in.
from shop manual: remove luggage cover and holder assembly remove speaker cover retainer nut and and screws securing the cover in place over the speaker assembly loosen and remove the speaker retainer screws securing the speaker in place, lift the speaker out enough to access the wire harness at the rear of the assembly disconnect the speaker harness remove the speaker installation is the reverse of removal
You do not need to remove the door panel to change your speakers. Remove the speaker cover, by prying outward on the speaker cover retaining clips. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
on what car???
Remove the door speaker cover. The cover is held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker. Reverse the process to install the new speaker.
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
carefully
you need to remove the door skins first there is a screw on the inside of the speaker cover that holds it on.
Right in front of the valve cover. You have to remove a cover to access it.
You don't, it slides back.
you un bolt it