answersLogoWhite

0

Just did it two hours ago. Followed the directions in the Haynes Service Manual. No problem. Remove triangular cover inside of the rear view door mounted mirror. It pulls straight out. The inside door handle is in two pieces. The cover piece must be pried off. Take care, don't use too much pressure and take your time. I used a flat wedge made from Plexiglas to reduce damage to the plastic parts. Behind the door handle cover there are two Phillips head screws that must be removed. The door lock knob must be removed. The door mounted speaker grill must be pried off. Again care must be exercised to prevent damage. The four Phillips head screws holding the door speaker must be removed. Lastly there are six Allen socket head screws along the panel edges that must be removed with a 1.5mm Allen wrench. the door panel should just about fall off being held by the various electrics which unplug with care and the door lock release which is easily broken if forced. Good Luck

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove the interior door panels of a 1998 Chevrolet Monte Carlo?

Remove the visible screws on the panel. Remove the screw and interior door handle cup. Tap the panel upward. DO NOT PRY OUT FROM DOOR! you will break the tabs that slide into the steel part of the door. Onece it is lifted staight up off the door remove the wiring connections for mirror and windows.


Where is astra fuel pump relaymk3 gsi 1998?

next to the ecu, drivers side remove interior sill plastic trim and kick panel


How do you remove the interior panel on the hatch of a 5-door 1998 Toyota Corolla?

To remove the interior panel on the hatch of a 1998 Toyota Corolla, first, ensure the vehicle is turned off and the hatch is open. Use a flathead screwdriver or trim tool to carefully pry off any plastic clips or covers concealing screws. Remove the screws, typically located around the edges and possibly near the handle. Finally, gently pull the panel away from the hatch, being cautious of any remaining clips or wiring connected to it.


How do you remove the front inner door panel of a 1998 Chevy Venture?

just use a minus scre driver and slide thru the interior cover, it will snap off the body.


How do you remove the inside handle off a 1998 civic?

Remove the door panel


How do you remove an interior door panel on a 1998 ford mustang?

Check out the post for changing the front speakers, same thing or The answer to the question can be found in the following site: http://www.mustangevolution.com/articles/20073/


How do you remove side interior panel 1998 Plymouth?

To remove the side interior panel of a 1998 Plymouth, first, make sure to disconnect the vehicle's battery for safety. Use a trim tool or screwdriver to carefully pry off any plastic clips or screws holding the panel in place, typically located near the door handle, armrest, or bottom edge. Once all fasteners are removed, gently pull the panel away from the door frame, being cautious of any electrical connectors or clips that may still be attached. Finally, disconnect any wiring harnesses if necessary, and the panel should come off.


How do you repair an interior door handle on a 1998 Chevy Silverado?

It is not too hard. You will have to remove the door panel, then you will see how the interior handle is riveted to the metal door frame work. You will need to drill these rivets out and install the new handle with either rivets or screws.


Cruise control vw 1998 cabrio?

What about it?


Instrument panel removal Ford Expedition?

How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine


Remove door panel on 1998 Ford Ranger?

The 1998 Ford Ranger door panel has eight retaining clips. Pry outward on each retaining clip. Remove the two door handle screws.


Where is the kick panel located on 1998 ford explore?

The kick panel is the interior plastic trim panel ahead of the front doors on the passenger and driver side next to the persons feet