Under the battery tray. You need to remove the battery and battery tray to gain access.
The module is located underneath the battery tray and mounted with 2 bolts from the top side. best way is to remove the battery and tray to get access.
The Battery Temperature sensor is located under the battery attached to the battery tray. Remove the battery and you will see it on the tray. You can then remove it from the top and then unplug it.
To remove the battery tray on a Citroen C3, first, ensure the vehicle is turned off and the keys are removed. Disconnect the negative battery terminal followed by the positive terminal, and then remove the battery itself. Once the battery is out, locate and unscrew any fasteners or clips securing the battery tray. Carefully lift the tray out of its position, ensuring that no wires or components are damaged in the process.
Remove - battery cable Remove + battery cable Remove hold-down bolt on front bottom of battery tray Remove battery
To remove the battery tray on a John Deere STX 38 yellow deck mower, first, ensure the mower is turned off and the key is removed. Disconnect the battery cables, starting with the negative terminal. Next, locate and remove the screws or bolts securing the battery tray to the mower frame. Once these are removed, you can lift the battery tray out of its position.
Underneath the battery, underneath the battery tray.
There is a 13mm bolt holding down a locking tray in the back of the battery. Remove that bolt and your battery should come out freely
under the battery, remove the battery and battery tray
On top of the engine, under the battery. You need to remove the battery and battery tray to get to it.
remove the battery and the battery tray. It is below the battery tray and is mounted to the inside front of the the wheel well.
The CCRM on a 96 Sable is attached to the left side (drivers side) of the battery tray. Undo the spring clamp to remove the CCRM from the tray. The electrical harness on the CCRM is short. If you need to remove the harness, first remove the battery, then remove the battery tray, then you will have room to rotate the connector to expose the 5mm nut that you must loosen to remove the harness connector.