To remove a Boxster convertible top from a vehicle, there are several screws that have to be removed at the point where the top meets the trunk. The bots must also be removed from the hinges on the sides.
The convertible top sensor for a 1998 Porsche Boxster is typically located near the convertible top mechanism, often mounted on the frame or the motor assembly that operates the top. It monitors the position of the convertible top to ensure it opens and closes properly. If you're troubleshooting, it may also be helpful to check the wiring and connections associated with the sensor for any issues.
The convertible top motor in a Porsche Boxster is typically located in the trunk area, specifically on the driver's side behind the rear wall. To access it, you may need to remove the trim panel and possibly other components in that area. This motor is responsible for operating the convertible top mechanism, allowing it to open and close. Always refer to the specific service manual for detailed instructions based on the model year.
It is not advised it repair a convertible top with tape. The types of tape that would survive the weather would be near impossible to remove later.
Cars trollingham Sweden but 9-3 sport convertible was made in the same factory as the Porsche boxster convertible in Dusseldorf
Unlatch the latches at the top of the window, then press the convertible top button down. this button is located near the armrest. If this does not work you must aquire a new convertible top motor. from the trunk, remove hyd. fluid from the conv. top pump, operate top by hand. worked for me for years
Repairs and replacement of the top are normally done with the frame on the car.
Coupe or convertible? Yet another un-specific question.
stop being a bum and take to a place
in the trunk remove battery cover. the top pump motor is on the top-remove the plug in the resovoir and fill with green dragons blood.
Goof off, or some bug and tar remover will release it.
A convertible.
don t do it you need to remove the rears seats the bolt from the hydrolics rod and the bolts from the botom of the convertible make sure all the clips are of behing the bolts and make sure you take of the wirre from the class you will need some body to help you to remove the top