there aren't any, only in the front the stupid people who designed the thing have written about them in the mannual but didn't actually put the dam things in :)
I cannot find how to remove the cup holder from the dash of my 2001 Pontiac Montana
Take it out
To remove the cup holder from a 2007 Audi convertible, first, ensure the vehicle is turned off and the key is removed. Use a flathead screwdriver to gently pry off any trim panel covering the cup holder, if applicable. Once exposed, locate and remove the screws or clips securing the cup holder in place, then carefully pull it out from its housing. Be cautious to avoid damaging surrounding trim during the process.
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
Open the cup holder and remove the two screws on the outside.
Remove original ashtray, remove 4 screws that hold ashtray mounting bracket. This will give access to the 2 screws that hold inner end of cup holder. The cup holder must be pulled all the way out to get to screws. Remove screws, remove 2 screws in front face, cup holder will come right out. Installed updated cup holder in 20 minutes, start to finish!
You need to tilt your drinking device to place in holder and tilt to remove.
Pull the cup holder out. Reach back, and at the top rear, center-left, is a tab. Press the tab down and pull out on the cup holder to remove it.
WHERE DO YOU GET A REPLACEMENT IN DASH PUSH IN CUP HOLDER FOR THE 2001 S40 VOLVO? FIRST :) I already have the new cup holder from Volvo! How do I replace it? You have the actual guestion listed, now where do I find the answer????
To remove the cup holder in a 1998 Toyota 4Runner, start by prying off the plastic trim surrounding the cup holder carefully to avoid breaking clips. Once the trim is removed, locate the screws or bolts securing the cup holder in place and remove them. Gently pull the cup holder out of its slot. If it's stubborn, ensure there are no hidden fasteners and use a flat tool to assist in prying it out.
To remove the cup holder from a VW Polo, start by prying off any trim surrounding the cup holder using a flathead screwdriver or a trim tool to avoid damaging the interior. Once the trim is removed, locate any screws or clips securing the cup holder in place and remove them. Carefully pull the cup holder out from its housing, ensuring not to force it. If the cup holder is stuck, check for any additional fasteners or clips that may be holding it in place.
To remove the cup holder from a 2005 Acura RL, start by using a flathead screwdriver to gently pry off the trim panel surrounding the cup holder. Once the trim is removed, locate the screws or clips securing the cup holder in place and remove them. Carefully pull the cup holder out of its housing, ensuring not to damage any surrounding components. Reassemble by following the steps in reverse order.