Remove the knee pad underneath the steering wheel, there are 5 sheet metal screws hidden between the carpet loops in the knee pad. Reach up and press the instrument cluster out a few inches, it is not held by screws just pressure. Remove the one nut holding a long bolt through the ignition lock. Turn the key to position one. Remove the long bolt by pushing upwards with a long nail or other bolt. Remove the trim piece around the key area by unscrewing it. Remove the ignition lock from under the dash. Disconnect the ignition switch.
The 1991 Mercury Sable ignition switch is held in place with a retaining ring. Loosen the retaining ring. Pull the ignition switch out. Remove the wiring harness from the rear of the ignition switch. Reverse the process to install the new ignition switch.
To remove the ignition switch on a 1991 Geo Storm, first, disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing the fasteners, exposing the ignition switch. Disconnect the wiring harness from the switch and remove the screws securing the ignition switch in place. Finally, gently pull the ignition switch out from the steering column.
How to remove ignition switch on a 91 Mazda Navajo
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.
The entire ignition switch assembly will unholy from the steering column. The key is required to remove the cylinder from the switch.
To remove the ignition switch from a 1991 Toyota Previa, first disconnect the negative battery terminal to ensure safety. Then, remove the steering column cover by taking out the screws and gently prying it off. Locate the ignition switch, disconnect the wiring harness, and remove the retaining screws or bolts. Finally, pull the ignition switch out of its housing.
Remove steering wheel and signal switch
Never mind figured it out
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
To remove the ignition from a 1991 Ford Laser, first disconnect the negative battery cable to ensure safety. Next, remove the steering column cover by unscrewing the retaining screws. Then, locate the ignition switch, disconnect the wiring harness, and unscrew the ignition lock cylinder using a key to turn it to the "On" position for easier access. Finally, pull the ignition switch out of the steering column.
To replace the ignition switch on a 1991 Mazda Miata, start by disconnecting the negative battery cable to ensure safety. Remove the steering column covers by unscrewing the screws and gently prying them apart. Then, disconnect the wiring harness from the old ignition switch, remove any mounting screws, and take out the switch. Install the new ignition switch by reversing the steps: secure it in place, reconnect the wiring harness, and reattach the steering column covers. Finally, reconnect the battery and test the ignition.
drop your steering column... not exactly sure where it is from there but that is the location of it.