Its held by 6 screws, 4 are visible the other two (8mm) are located at the back of the engine, very hard to find so use a mirror... Good luck, IB (Netherlands)
yes
oil in the radiator water is normally caused by a faulty inlet manifold gasket.
Hi you need to remove the front bumper, grill this gives you some room at the front undo the two outer bolts at the front manifold 5mm allen keys then move water pipe to the side this then allows room to undo the other 4 bolts at the front you need to undo the 2 bolts at the back that secure the mainifold to the head. you will need to remove the air box, inlet trunking and all the wires cables etc that are connected to it hope that helps if you google V6 inlet removal on VW golf Mk4 its almost the same just less a pot :)
Because its a V6 engine and the other 3 plugs are hidden beneath the inlet manifold.
How do i time rover 75 v6 engine/
On v6 remove upper intake manifold
The 2014 Land-Rover Range-Rover has a V6 engine.
To remove the starter motor from a Rover 75 2.5 V6, first disconnect the battery to ensure safety. Then, access the starter motor, which is typically located near the transmission at the rear of the engine. Remove the electrical connections and the mounting bolts securing the starter motor in place. Finally, carefully pull the starter motor out of its housing.
on the V6 you need to remove the inlet manifold and if you release the o/s engine mount at the top the engine will drop enough to give access to the rear 3 plugs, what a nightmare
The 2014 Land-Rover Range-Rover-Sport has a V6 engine.
if its the V6, you can see the 3 in front, and you have to remove the intake manifold to ge the ones in back...
assuming its a V6... You have to remove the air intake manifold in order to get to the back three plugs. The front three you simply remove plastic cover and remove.