A pound of C4 and a website with no actual answer.
You don't remove the fender; the battery is behind the inner fender well behind the rear driver's-side tire.
which fender frontor rear front
Remove the driver's side rear wheel; remove the inner fender well behind the wheel.
Removing the rear fender from a 2007 Vulcan 900 is not hard at all. Simply remove any screws or fasteners and wiring that are holding the fender in place. There are tutorials for removing the fender online at YouTube.
Interstate/Aspencade, quote from my shop book.......... Bike On Center stand, remove the four left saddlebag mount bolts and 2 nuts. remove the reflex reflector from the rear fender, remove the left saddlebag and rear fender. remove the rear bumper by removing the four bolts and retainers. remove the axle nut and RIGHT shock absorber lower mount bolt. remove LEFT shock absorber lower mount bolt. Remove the axle pinch bolt. Raise the rear wheel with a block large enough that the axle clears the muffler. Remove the axle and move the caliper assembly outward to allow removal of the rear wheel. Remove the rear wheel : Note: Do not depress the brake pedal while the wheel is off. Good luck.
with the motorcycle on the ground install tire change tool from tool kit across the tabs on the frame then put motorcycle on center stand. Remove rear fender bolts to raise rear fender, remove axle bolt then remove rear tire.
Unscrew the rear chrome screw on top of fender and a screw on left and right side of seat and pull up and back and remove.
It has to be cut off.
You must remove the entire rear fender.
The procedure differs depending on the year and model, but basically you remove the wheel, disconnect any wiring and remove all fasteners holding the fender in place.
Not that I'm aware of.
To remove the rear fender on a Harley Fat Bob, start by disconnecting the battery to ensure safety. Next, remove the seat and any side panels that may obstruct access to the fender. Unscrew the bolts securing the fender to the frame and disconnect any wiring for the tail light and turn signals. Finally, carefully lift the fender off the mounting brackets to complete the removal.