To remove the rear spoiler from a Citroën Saxo VTS, start by opening the hatchback to access the spoiler's mounting points. Carefully detach any clips or screws securing the spoiler to the vehicle, usually located on the underside. Once these fasteners are removed, gently lift the spoiler away from the hatch, taking care not to damage the paint or surrounding areas. Finally, if there are any adhesive strips, you may need to carefully peel them off or use a heat gun to soften the adhesive for easier removal.
sledge hammer and a good towing yoke to tow it off
To remove the rear spoiler from a Citroën Saxo VTR, first, ensure the vehicle is parked securely and the battery is disconnected to avoid any electrical issues. Carefully locate and remove any screws or bolts securing the spoiler to the rear of the car, often hidden under plastic covers or trim. Once these fasteners are removed, gently pry the spoiler away from the body, taking care not to damage the paint or surrounding areas. Finally, clean up any adhesive residue left behind before reassembling any removed components.
what colour fuse make the heater work in citreon saxo 1.1
drill 2 holes at each end of the bootlid to correspond to the threaded bolts on the spoiler then sit the spoiler in the holes and bolt from inside.
To fit a spoiler to a Mk2 Saxo, first ensure you have the correct spoiler designed for this model. Clean the area where the spoiler will be attached, then position it accurately on the rear of the car, marking the drill points. Drill holes carefully, and use the provided screws or adhesive to secure the spoiler in place. Finally, check the alignment and ensure everything is tightly fastened before finishing up.
Yes!
as you look at the front of the car with the bonnet open ... look down the rear of the grill on the right hand side ... the cap tells you
Yes it has two reverse lights
how to repair a citreon saxo indicator bulb
remove rear seat, fit roll cage, attach to that.
Follow link. http://www.southwestcruisin.co.uk/forum/viewtopic.php?t=15593
rubber seal round edge perrished or not on rite