pull from around the middle of the seat at the edge then flip up
To remove the back seat of a 1990 BMW 750iL, start by locating the seat release mechanisms, typically found at the front of the seat cushion. Pull the release levers or push the buttons to unhook the seat cushion from its mount. After removing the cushion, check for bolts or screws holding the seat back in place, usually found at the base or sides, and remove them. Finally, carefully lift the seat back out of the vehicle.
Under the back seat
Need to take out back seat
To remove the back seat of a BMW 745Li, start by locating the seat release mechanisms, usually found at the bottom of the seat near the front. Pull the release levers or push the clips to unlock the seat. Then, gently pull the seat upward and out of the vehicle. If needed, remove any fastening bolts or screws that may be securing the seat in place before lifting it out.
To remove the rear seat on my 91 535i you have grab under the seat about half way and then pull straight up. Hope this helps you out
To remove the seat of a BMW Z3, start by sliding the seat all the way forward to access the rear bolts. Use a socket wrench to remove the bolts securing the seat to the floor. After that, slide the seat back to access the front bolts and remove them as well. Finally, disconnect any wiring for seat adjustments or airbags before carefully lifting the seat out of the vehicle.
You can remove the back seat by pulling on the front edge of the seat with both hands equally spaced apart. If this hasn't been done in a while you'll have to pull hard.
use ignition key in helmet lock on right side of seat turn and seat will unlock. lift main seat up then you can remove the back section.
IF IT IS THE SAME AS A '93 IT IS UNDER THE BACK SEAT PASSENGER SIDE
Yes, I actually used a 1991 535i seat and put it in my 1990.
IF IT IS THE SAME LOCATION AS A '93 THEN IT IS UNDER YOUR BACK SEAT PASSENGER SIDE
To remove the back seat of a BMW X series, first, locate and remove any bolts or screws securing the seat to the floor, which may be hidden under plastic covers. Then, gently pull the seat upwards to detach it from the mounting points. Finally, if the seat has a split design, repeat the process for the other section. Always consult your owner’s manual for specific instructions related to your model year.