answersLogoWhite

0

The battery is located under the passenger seat in the Picasso. Caution should always be used when removing the battery as apparently it can corrupt the cars computer system if disconnected incorrectly. Everything should be switched off and all doors closed for at least 3 minutes before disconnecting, to allow the computer to go to sleep. If this is not followed then the software can be corrupted. Do not operate any equipment for the 3 minutes before disconnecting. (Check out the Citroen 3 minute rule)

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you remove bellhousing from citroen xsara Picasso?

Remove bellhousing from citroen xsara picasso


What is the battery voltage for a citroen Picasso?

12V


Do you have to remove the seat for the battery of a citroen xsara Picasso?

It tips forward. remove headrest, and release to sprung catches at rear of seat, it then will tip forward


How to Remove the headlights on a citroen xsara Picasso?

According to the manual,you have to remove the front bumper


Why does the battery light come on in your citroen xsara Picasso?

The alternator needs attention or replace


How do you remove the aerial of a Citroen Xsara Picasso?

Unscrews from base on roof external


How do you remove engine from citroen Picasso?

take out bolts & wires lift it up & put it on floor


How do you Remove the gear knob on citroen xsara Picasso?

wiggle it a little and then pull out. it is so easy.


How do you remove the engine cover on citroen xzara Picasso to get to the spark plugs?

were is engine cover wot does it do


How do you remove gear knob on citroen xsara Picasso?

wiggle it a little and then pull out. it is so easy.


How do you remove wheel arch liner on citroen xsara Picasso?

You cant as no one on the internet will tell you


How do you remove steering column cover on Citroen Picasso?

To remove the steering column cover on a Citroen Picasso, first disconnect the vehicle's battery for safety. Then, remove any screws or fasteners securing the cover, typically located underneath the steering column. Once the screws are removed, gently pry apart the two halves of the cover, being cautious not to damage any clips or connectors. Finally, lift the cover off to access the steering components.