To remove the exhaust emission sensor on a Vauxhall Corsa, first, ensure the engine is off and cool. Locate the sensor on the exhaust system, usually near the catalytic converter. Disconnect the electrical connector by pressing the tab and pulling it out. Finally, use a suitable wrench to unscrew the sensor from its threaded port, taking care not to damage surrounding components.
your temp sensor should be in the front bumper
THE CRANKSHAFT SENSOR IS LOCATED AT THE REAR OF THE ENGINE UNDER THE STARTER MOTOR. REMOVE AND REPLACE BUT MAKE SURE THE SERFICES ANE CLEAN AND USE A NEW O RING.
crankshaft sensor
Corsa sport is the best...
Look on the transmission by where the axles come out
Look behind the driver wheel at the cranckshaft pulley. There will be a sensor there. It is the pulley with the teeth.
Its between the Air Filter and the Engine inlet
To remove the gearbox from a Corsa B, start by disconnecting the battery and draining the transmission fluid. Then, remove the drive shafts, and detach any connected parts such as the exhaust and starter motor. Next, unbolt the gearbox from the engine and any supporting brackets, and carefully lower the gearbox from the vehicle using a jack. Ensure to follow safety procedures and consult a repair manual for specific torque settings and detailed steps.
To remove the cylinder head of an Opel Corsa 1.7 diesel, first disconnect the battery and drain the coolant and oil. Remove the intake and exhaust manifolds, along with any attached components, such as the turbocharger if applicable. Then, unbolt the cylinder head by loosening the head bolts in the correct sequence and order. Carefully lift the head off the engine block, ensuring that no debris falls into the engine.
There's a problem in the emissions system. You'll have to get it properly diagnosed in order to repair it.
how to replace crankshaft sensor on Corsa 1-2 2002 .Which parts require removing to replace unit
its located above the starter motor.