pull it down hard pops out
it is on the windshield behind the mirror..there is a black plastic cover behind the inside mirror, sensor is inside that cover..
remove drivers inside door panel and there are 2 or 3 bolts that hold mirror on from the inside after you diconnect the wire harness if it is a power mirror
Remove the inside door panel. Remove the wiring harness from the mirror. Remove the mirror retaining bolts. Reverse the process to install the new mirror.
The first step to remove the interior rear view mirror on a 1990 Mercedes 300E is to heat up the adhesive with a heat gun. Twist back and forth as the adhesive melts and pull the mirror from the window.
remove drivers inside door panel and there are 2 or 3 bolts that hold mirror on from the inside after you diconnect the wire harness if it is a power mirror
To replace the inside rear view mirror on a Mercedes C230, first, ensure the vehicle is turned off and the ignition key is removed. Carefully detach the existing mirror by loosening the mounting set screw, usually located at the base of the mirror. Remove the mirror from the mount and disconnect any wiring if it’s equipped with features like auto-dimming. Finally, install the new mirror by reversing the process: connect any necessary wiring, secure it in place, and tighten the set screw.
You have to remove the complete mirror from the car. Remove the nuts from the inside.
Remove the inside door panel of your Chevrolet Astro Van. Remove the wiring harness from the mirror. Remove the side mirror retaining bolts.
To remove the rearview mirror on a 2002 Mercedes ML320, first, locate the mounting set screw at the base of the mirror. Use a Torx screwdriver to loosen the screw, then gently slide the mirror off its bracket. If the mirror has an electrical connector for features like auto-dimming, carefully disconnect it before fully removing the mirror. Make sure to handle the mirror with care to avoid damage.
Passenger mirror access is same as drivers side. Three screws accessible inside door panel to remove entire mirror assembly. To remove mirror within the mirror assembly it just pulls off - snap fit of mirror mount to drive.
Remove the plastic cover on the inside behind the mirror and then remove the three nuts holding ther mirror on. When you pull out the mirror unclip the wiring harness.
Grab it and twist it 90 degrees. It comes right off.