answersLogoWhite

0

Hey, You didn't say what year you have so this may apply or not. its good for a mk4. 1. Remove the front driver's side wheel. 2. Remove the wheel arch liner (some torxs screws and 2 plastic fasteners). [I managed to avoid removing the wheel arch liner completely. I simply folded the part obscuring the washer bottle out of the way - roghol] 3. In the wheel arch unbolt the bottle from the car [I used a socket set with a socket extension for this as the bolt is a little hard to get at. However, you can undo it using pliers if you like and don't mind contorting a little. The required socket is 10mm - roghol]. 4. Open the driver's door, there are 2 bolts behind the door hinge, remove these [I found it easiest to do this while sitting in the driver's seat. You need to make sure the driver's door is open just the right amount to allow you to see the two bolts. Again, you'll need a 10mm socket and a socket extension. I'm sure it's possible to unscrew the bolts from outside the car but they look quite difficult to get at from that angle - roghol] 5. Unscrew / unclip the coolant expansion tank (you don't have to remove the pipes) and move it out of the way [The coolant expansion tank is held on with just one screw, plus a metal tab attached to the engine compartment which is inserted through a plastic slot on the tank. To lift the coolant expansion tank clear of the metal tab you'll need to widen the plastic slot using a flat-headed screwdriver or similar tool - roghol] 6. Remove the washer bottle neck (just pull it) 7. Pull bottle down, unclipping the hoses and power cable [There are two hoses and one power cable. To completely remove the washer bottle from the car you'll need to unclip the two retaining plastic tabs on the side of the washer bottle so that the power cable can be fully detached - roghol]. 8. Refitting is the reverse of removal. Cheers James

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Is there a rear washer bottle on a Ford Fiesta?

no the one in engine bay does em both


What is the large white container in the Ford Fiesta engine compartment Not the washer bottle?

hi that's for your cooling fluid for the radiator.


How do you remove the washer bottle from ford ka?

To remove the washer bottle from a Ford Ka, first, ensure the vehicle is off and the keys are removed. Locate the washer bottle, typically found near the front of the engine bay. Disconnect the washer fluid hose and the electrical connector from the pump, if applicable. Finally, unfasten any retaining clips or bolts securing the bottle and carefully lift it out.


How do you remove washer bottle from 2005 Ford Mondeo?

To remove the washer bottle from a 2005 Ford Mondeo, first, ensure the vehicle is turned off and the keys are removed. Disconnect the negative battery terminal for safety. Then, access the washer bottle by removing any necessary components in the engine bay, such as the air intake duct if it obstructs access. Finally, disconnect the washer hose and electrical connector, and unbolt or unclip the washer bottle from its mounting points before carefully lifting it out.


How do you remove an airbag Ford Fiesta?

How do you remove the bottom front right airbag on a 2011 ford fiesta.


How do you remove the dashboard on a 1996 Ford Fiesta to repair the heater?

How do you remove the dashboard on a 1996 Ford Fiesta


Where is the washer bottle on Ford Focus?

The windshield washer bottle, on a Ford focus, can be located in the engine compartment. The container is near the front of the engine compartment on the drivers side.


How can you remove inside door panel of ford fiesta 2.5?

removel of door panal in ford fiesta 2002


Where is Ford territory rear washer reservoir?

The front and rear reservoirs are the same one with two pumps, one front and one rear, on the left hand front skirt next to the air box. you will need to partly remove the left hand guard liner to inspect the pumps, hoses and wiring


How do you change a windshield washer motor on a 1994 Ford Thunderbird?

Find washer bottle remove, usually pump is in the bottom of bottle. undo connection then remove bottle from car to make the pump removal easy, twist and pull until pump comes out install new pump making sure the gasket is going to seal and not leak. reconnect, reinstall bottle and fill.


Where do you fill the window washer reservoir of a 2005 Ford Festiva?

There is no such thing as a 2005 festiva you Prolly have a fiesta...


Where is the front washer pump located on a 2001 Ford Taurus wagon?

Your washer pump is located right in the washer fluid bottle on the bottom of it.