Autoglass....
The windscreen washer pump on a Fiat Punto is typically located in the engine bay, attached to the washer fluid reservoir. It is usually situated near the front of the car, on the driver's side. To access it, you may need to remove the reservoir or other components depending on the model year. Always consult the vehicle's manual for specific instructions related to your model.
The ECU is located under the Scuttle panel at the base of the windscreen
The fuses are behind the small recess in the dashboard below and right of the steering wheel in right hand drive 55S. Remove the two crosshead screws at the top to remove this and reveal the fuses.
Fiat Punto was created in 1993.
The Fiat Punto is manufactured by the company Fiat. Fiat is an Italian manufacturing company. The manufacturing of the Fiat Punto started in 1993 and is still currently being produced.
Use hammer.
To change the windscreen washer reservoir in a Fiat Punto, first ensure the car is turned off and the key is removed. Locate the reservoir, usually found near the front of the engine bay, and disconnect any hoses or electrical connections attached to it. Remove any mounting bolts or clips securing the reservoir, then lift it out. Install the new reservoir by reversing the steps, ensuring all connections are secure before refilling it with washer fluid.
No its different
Fiat Punto 1.9l ltd service manual?
if its on a punto gt is a lot of work.have to remove inlet manifold costs a lots for the job to be done in a garage.
Bad wire connections to the pump. Shot pump.