# Remove cargo hooks by prying out center pin in cap abnd then pulling the whole cap out # Pull back the trunk liner to expose the wiring harness # Pull off the plastic wire harness clips to expose 2 10mm bolts # Remove bolts # From the exterior - pull the tail light assembly straight out (there are 2 pop clips which will require a good yank - I suggest using tape to protect the body/bumper where you will pry from)
how to change the rear tail light bulb on a 2004 Nissan maxima
How do you replace the rear brake light bulb on a 2001 Honda civic?"
change rear brakes on a 2004 Nissan maxima
w to replace center brake light in 2004 jeep liberty
How do you replace rear window brake light bulb in the 2004 Hyundai Santa Fe?Read more: How_do_you_replace_rear_window_brake_light_bulb_on_2004_Hyundai_Santa_f_e
Can figure out how to remove rear rotor assembly to replace wheel bearing assembly on a Maxima 2004 Nissan
replace brake light switch located on brake pedal under dash
To replace the third brake light on a 2004 Mercedes E-Class, first, open the trunk and remove the trim panel covering the brake light assembly. Disconnect the electrical connector and remove the screws securing the brake light. Replace the old light with the new one, reattach the screws, and reconnect the electrical connector before replacing the trim panel. Test the light to ensure it functions properly.
I just had this problem on my 98 Frontier because the brake lights were staying on. I had to replace the brake light switch and the brake light button for it to go out.
How much does it cost to replace a 2004 nissan maxima transmission and motor mounts
2004 Nissan Maxima brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
To replace the third brake light on a 2004 Mitsubishi Endeavor, first, open the rear hatch and locate the cover for the brake light assembly. Remove the screws securing the cover, then gently pull it away to access the bulb. Twist the old bulb counterclockwise to remove it, replace it with a new bulb, and reassemble the cover by securing it with screws. Finally, test the new brake light to ensure it’s functioning properly.