Take the cover off in the trunk and turn the bulb socket to the left.
Check the bulbs, check the fuse, check the brake light switch, in that order.
you dont you get a new car
Look inside the trunk under the light for bolts to remove the light.
brake and abs light on , on 1994 Chevy Cavalier Z24
To replace the brake light switch on a 1994 Mercedes C280, first disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is typically mounted on the brake pedal assembly. Remove the electrical connector and the switch by unscrewing it or releasing any clips holding it in place. Install the new switch, reconnect the electrical connector, and reattach the battery terminal before testing the brake lights.
It's just above the brake pedal, connected to the brake pedal arm. The switch comes out with two screws and the new one plugs in. But before you replace the switch, check the adjustment.
special bit for light lens cover, t 10 or t 20 bit light bulb unscrew from socket replace observe ligh light place foot on brake , re screw use brick on brake pedel
replace the headlight switch its wore out replace the headlight switch its wore out
Remove brake light interior trim panels. Then you push and twist the socket for the brake light that needs replacing. Then pull out socket. then pull out bulb from socket and place new bulb in the light socket. Once bulb is installed into light socket. Place the socket where you removed it from brake light housing. Push and twist clockwise to lock back in place. Then replace trim panels.
check with the dealership there was a recall to replace the switch for free! I had mine replaced...tombo
on your brake pedal lever.
Should be a screw on either side - remove and cover should lift off