0
What else can I help you with?
How do you replace the headlight bulb located on a Rover 216 SLI N Reg?
Working inside the engine compartment unclip the relevantcircular plastic cover and remove it from the rear of the headlamp unit. Unplug the wiring connector then unhook the bulb retaining clip and pivot it away from the rear of the lamp. Withdraw the bulb from the headlight unit. When refitting a new bulb take care not to touch the bulb glass with bare fingers as it can harm the bulb, the rest is just a reverse of the above.
What rover is the same as a Honda concento?
the rover model is early rover 200 series ie, 214, 216.
Where are the timing marks for rover 216?
would like a picture
Whats the Rover 216 sli specification?
fuse for the immobiliser which one is it
How do you change the gearbox fluid on a rover 216 automatic?
You need to remove the transmission oil pan. Use an oil pan to catch the old fluid that will come out. Replace the filter while the pan is off and replace the pan gasket.
How do you fit a new soft top to a rover 216 hi Can anybody help me by giving me advise on fitting a new soft top on a rover 216 thanks in anticipation?
yeah i'd also like to know that!!
Why do you have 2 dip sticks on your rover 216?
One for the engine, one for the transmission.
Where is the diagnostic plug for a rover 216?
down by the clutch pedel, closer to the radio tbh,
Do you have to reset anything after changing the battery on 1999 rover 216 auto to enable it to start?
No
What is the Correct gap for rover 216 spark plugs?
0.85mm, but .8 or .9 will do fine also.
What is the recommended tire pressure for a 1999 rover 216 Si?
Just been looking myself and is 30.
How do you change the oil and filter in a rover 216?
To change the oil and filter in a Rover 216, first, ensure the engine is cool and secure the vehicle on a level surface. Remove the oil drain plug and let the old oil drain into a pan. Replace the oil filter using an oil filter wrench, ensuring to lubricate the new filter’s gasket with a bit of new oil before installation. Finally, replace the drain plug, fill the engine with new oil through the dipstick tube, and check the level to ensure it's within the recommended range.
