Hi there, I have done this on my 1994 306 - I assume it is the same, you need to drop the lighting panel down ( mine fell out not sure how to do this bit) then you just undo the bolt, remove the connector lift the aerial off from the outside and pop the new one in - its a good idea to clean the paint after removing the old aerial and before you fit the new one to ensure that you get a snug fit, make sure that the seal is intact on the new aerial otherwise it will leak. reconnect the aerial lead, do the bolt back up and pop the lighting back into place. enjoy the radio good luck
Possibly not, the 306 was face-lifted in 1998 with a variety of changes. Check with the dealership.
cant be replaced
Don't really think so, the 306 has one short and one long drive shaft with an intermediate bearing carrier. You could try a dirct comparison side by side.
Unscrew the aerial mounting bolt on the wing. Turn on the radio and pull out the old aerial mast. Now put in the new aerial mast and get some one to push the button in the cab to wind the aerial down. The motor will draw in the new aerial mast, replace the bolt.
To replace the aerial on a VW Polo, first, ensure the vehicle is turned off and the radio is disconnected. Carefully remove the old aerial by unscrewing it from the base, which may require a special tool or a simple wrench, depending on the model. Once removed, install the new aerial by screwing it into the base securely, and reconnect the radio. Finally, test the reception to ensure the new aerial is functioning properly.
I had an hj61 cruiser. the aerial could be accessed from a cutout in the panel under the bonnet. Try this. It was obvious once i looked for it.
178 km/h
Take your car to a gararge
Check to make sure you have enough coolant and motor oil. If those are okay, you need to check your theromostat. Worst case would be that you need to replace the water pump.
how to replace a starter on a 1995 Lincoln Continental
The Tonight Show with Jay Leno - 1992 3-306 was released on: USA: 28 April 1995
To change the aerial on a 1992 EB Falcon, first, ensure the vehicle is turned off and remove the radio fuse to avoid any electrical issues. Access the aerial by unscrewing it from its base, typically located on the front fender or roof. Disconnect the electrical connector and any retaining clips, then replace it with the new aerial by reversing the removal process. Once installed, reconnect the electrical connector and replace the radio fuse before testing the new aerial for functionality.