To replace the driver side headlight bulb in a 2002 Cabrio, first, open the hood and locate the headlight assembly. Disconnect the wiring harness by squeezing the tab and pulling it off. Remove the rubber dust cover, then twist and pull the old bulb out of the assembly. Insert the new bulb, ensuring not to touch the glass, replace the dust cover, and reconnect the wiring harness.
To change the passenger side headlight on a 2002 VW Cabrio, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then carefully pull it out. Disconnect the wiring harness from the back of the headlight bulb, replace the bulb with a new one, and reassemble the headlight by reversing the removal steps. Ensure everything is securely fastened and test the new bulb before closing the hood.
My daughter has a 2002, and you must take it to the dealer, so we were told.
Here's a great video that shows you how to replace the headlight on a 2002 Toyota Camry: carcarekiosk.com/video/2002_Toyota_Camry_LE_2.4L_4_Cyl./lights/headlight
Work from behind light fixture Remove wire clip and twist bulb to remove Note: The above only works for the passenger's side headlight. The driver's side light is harder to get to. To replace the driver's side headlight remove the battery and it's hold down.
To replace the AC clutch discharge the freon, remove the clips, and remove the screws under the bumper. Remove the driver side headlight, and bolts.
To replace a headlight on a 2002 Honda Civic first prop the hood open. Locate the headlight housing inside the engine compartment. Find the bulbs and remove them. Install the new bulbs.
it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it.
In a 2002 Volkswagen Cabrio, the fuse box is located in the driver's side footwell. You can find it behind a cover panel on the left side of the footwell, near the door. To access the fuses, simply remove the cover by sliding it off or pulling it down.
You don't. Instead, you replace the entire assembly.
You have to remove the battery, then the frame holding the battery and the fuse box. After that you can remove the cover to access the bulbs. Its an annoying hassle just to replace the bulb.
By removing the locks that hold the headlight assembly in place you can wiggle the headlight assembly out to gain access to the headlight bulbs for replacement.
They should be both tied in together