0
Do NOT touch the bulb with your fingers. Only touch the base. Grease from your fingertips will significantly shorten the lifespan of the bulb and you will repeat this again, soon. Turn off the lights. Open the hood. There are two pins holding the headlight assembly in place, above the headlight assembly. Remove both pins on the side you are replacing the bulb by turning their top bars out of their clips, then pull the pin straight up. Pull the headlight assembly away carefully, as the bulbs are still attached to the wire harness behind them. Turn the required bulb in its socket until it is loose, then pull it out. Separate the wire plug from the base of the bulb. Use a tool like a coin or a screwdriver to loosen the wire plug retainer, if necessary. Install the new bulb in the socket of the light assembly. If the bulb does not fit in the socket, you are probably trying to install the low beam bulb in the high beam socket, like I did. Then plug the wire into the base of the bulb assembly. Reinstall the headlight assembly . Reinstall both pins, and turn the top bars back into the clips. Close the hood. Check the lights to make sure you got the correct bulb. Happy driving.
What else can I help you with?
How do you replace driver side headlight on a 2004 Jeep Liberty?
To replace the driver side headlight on a 2004 Jeep Liberty, first, open the hood and locate the headlight assembly. Disconnect the power connector from the back of the headlight by pressing the tab and pulling it off. Remove the retaining clip or screws that hold the headlight in place, then pull the headlight assembly out. Insert the new headlight, secure it with the clip or screws, and reconnect the power connector before closing the hood.
How do you replace headlight bulb on 2004 Mazda Tribute?
How do you replace headlight bulb on 2004 Mazda Tribute?
How do you replace driver side headlight bulb 2004 touareg?
To replace the driver side headlight bulb on a 2004 Volkswagen Touareg, first, open the hood and locate the headlight assembly. Disconnect the electrical connector from the back of the headlight by pulling it straight off, then remove the retaining clip or turn the bulb socket counterclockwise to release the old bulb. Insert the new bulb into the socket without touching the glass, secure it in place, reconnect the electrical connector, and ensure the headlight is functioning properly before closing the hood.
How do you replace the headlight bulk on a 2004 Hyundai 2004 XG350L?
How do you change a headlight bulb on 1 2004 Hyundai XG 350?
How much to replace fuel pump on a 2004 Tahoe?
$720.00
How do you replace the headlight bulb in a 2004 Mitsubishi Diamante?
how to replace bulbs on a 2009 mitsubishi eclipse
How do you replace a daytime running light on a 2004 Suburban?
To replace the daytime running light on a 2004 Suburban, you will have to first remove the two metal pins that can be found on top of the headlight. The headlight assembly can be removed next. Pull out the plugs that are connected to the headlight assembly. Replace the bulbs and then reconnect the assembly.
Where is the fuse for the heated seats located on a 2004 Chevy Tahoe?
The fuse for the heated seats on a 2004 Chevy Tahoe is located behind the e-brake. It is in a black plastic box on the driver's side.
How do you replace the driver's side Inside door handle on a 2004 Toyota Camry?
= How do you replace the driver's side Inside door handle on a 2004 Toyota Camry? =
Can you replace a 2000 landrover discovery headlight with a 2004 headlight?
No, the 2000 takes a 9003 bulb and the 2004 takes a 755 bulb. See sources and related links below.
Cost to replace water pump for 2004 Chevy Tahoe?
Yourself, about 90$. Mechanic, about 200.
How do you replace the side mirror and not the housing on a 2004 Tahoe?
go to parts house or yard ( save $100 ) replace entire housing
