peel bak the carpet in the he rear of the light assembly unit, there are two clips to be moved and the unit pops out. replace the bulb and reassemble
To replace the rear light cluster unit on a Peugeot 307, first, open the rear hatch and remove the access panel in the trunk interior to expose the light cluster. Disconnect the electrical connector and unscrew the securing bolts of the light unit. Carefully pull the light cluster out and replace it with the new unit, reconnect the electrical connector, and secure it with the screws. Finally, test the lights to ensure everything is functioning properly before replacing the access panel.
To replace the reversing light bulb on a Peugeot 508 SW, first, open the trunk and locate the tail light assembly. Remove the access cover or the entire tail light unit by unscrewing the necessary screws or clips. Carefully twist the bulb holder counterclockwise to remove it, then pull out the old bulb and replace it with a new one. Reassemble the tail light unit, ensuring everything is securely fastened before closing the trunk.
To replace a fog light on a Peugeot 207CC, start by turning off the vehicle and disconnecting the battery for safety. Remove the screws or clips securing the fog light cover, then carefully detach the cover. Disconnect the wiring harness from the old fog light, replace it with the new unit, and reconnect the wiring. Finally, reattach the fog light cover and reconnect the battery before testing the new fog light.
Replace just the mirror unit (complete with cover). They are sold on ebay for between $15 - 25 per unit. You don't have to replace the entire visor.
Remove backing plate on headlight unit.
It may be a blown bulb in the warning light. Or it may be the tank sender unit is faulty.
In the Daewoo Lanos, the heater light typically refers to the indicator for the heater, which is part of the climate control panel. To replace it, you will need to remove the dashboard panel and the climate control unit. Once the unit is accessible, locate the bulb for the heater indicator, remove it, and replace it with a new one. After replacement, reassemble the dashboard to complete the process.
where is the rev counter sender unit in peugeot 206 how to get at it
To change the backlight bulbs in the heater controls of a Peugeot 306, first, remove the surrounding trim panel carefully to access the controls. Disconnect the control unit from the dashboard and locate the bulb holders on the back of the unit. Twist and remove the old bulbs, then replace them with new ones, ensuring they are properly seated. Reassemble the control unit and trim panel, and test the lights to confirm they work.
Low oil pressure, or the oil pressure sending unit is defective. If the oil level is full, then the oil pump is weak or the sending unit is bad. Replace the oil pressure sending unit and see if that solves the problem. If not, seek professional help. Do not continue to drive the car in this condition.
Almost any cold air intake system you buy will come with complete instructions for that unit.