0
follow your radiator hoses, one of them is going to go to a housing. In it is your thermostat. Having bought the new one. drain your radiator in a pan, remove the radiator hose, remove the two bolts on the housing pull off, scrape clean the housing and mating surface on the bloick, apply a little permatex to hold new gasket in place, (if it comes with one) pay attention to wich side of thermostat goes toward motor it will say then put the housing together tighten by hnd replace hose and fill radiator back up with 50/50 mix antifreeze While you have the housing out look and see fi it has a bleeder on it or very near on a line. Sometimes these systems need to be burped. Let the motor run to get everything inplace and break open the bleeder if so equiped until fluid come sout, top off and good to go
What else can I help you with?
How do you replace the thermostat on a 2003 Mazda Protege ES 2.0?
how to replace the thermostat on a 2003 Mazda protege es 2.0
How do you replace the thermostat on a 2003 impala?
deal with it buddy
How do you replace the thermostat on a 2003 Ford Escape?
The thermostat, in your 2003 Ford Escape, by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will easily come out. Reverse the process to install the new thermostat.
What is the estminated Cost for dealership to replace thermostat on 2003 trailblazer?
570
How do you replace a thermostat on a 2003 Buick Century?
Drain the radiator. Remove the top radiator hose on the 2003 Buick Century. Unbolt the hose inlet. Remove the inlet housing and take out the thermostat. Replace the thermostat, install the housing and top hose, and refill with antifreeze.
Your 2003 jeep liberty is running hot and blowing antifreeze What could be the problem?
Thermostat sticking. Replace thermostat and gasket.
The antifreeze will not heat up in a Dodge ram 2003?
Thermostat is most likely stuck in the open position; replace the thermostat.
How do you replace a thermostat in a 2003 grand am 2.2L L4 ecotec?
The thermostat on a 2003 Pontiac Grand Am 2.2L L4 Ecotec is replaced by removing the upper radiator hose and unbolting the thermostat housing. The thermostat can then be removed, a new gasket installed, and the replacement thermostat put in place.
How do you change air temperature sensor on 2003 Astra?
how to change air temperature sensor on astra 2003 how to change air temperature sensor on astra 2003
How do you replace the thermostat on a 2003 madza mpv?
To replace the thermostat on a 2003 Mazda MPV, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the hoses connected to the thermostat housing. Unbolt the thermostat housing to access the thermostat, replace it with a new unit, and reassemble everything, ensuring to fill the cooling system with the appropriate coolant afterward. Finally, reconnect the battery and check for leaks.
How do you replace thermostat on 2003 Mazda mpv?
To replace the thermostat on a 2003 Mazda MPV, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator and remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, take out the old thermostat, and replace it with a new one, ensuring the gasket is properly seated. Reassemble the housing, reconnect the hose, refill the coolant, and reconnect the battery.
How do you replace thermostat on 2003 ford Thunderbird?
To replace the thermostat on a 2003 Ford Thunderbird, first, disconnect the negative battery cable and allow the engine to cool. Drain the coolant from the radiator, then remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with a new one (ensuring the gasket is in place), reassemble the housing, and reconnect the hose. Finally, refill the cooling system with coolant and reconnect the battery.
