If you are sure that you can replace weatherstripping on your car by yourself without going to a professional, the first step you should do is to remove the old weatherstripping which can be pulled off with a pliers or vise-grip. Grab an end of the weatherstripping and pull up. Once you start to get the weatherstripping to come up, fold the piece over the strip you're pulling on, creating a U shape, and continue to firmly, slowly pull off the weatherstripping. Use a flat-head screwdriver and flat putty knife to scrap off excess weatherstripping and adhesive. Then you have to measure the length of weatherstripping you need to outline all of the door frames and trunk. Buy weatherstripping and weatherstripping adhesive from an auto repair store. Cut the proper-sized lengths of weatherstripping for each area. Read the directions completely on the weatherstripping adhesive. Apply weatherstripping adhesive to the area where you're going to lay the weatherstripping. Start laying the weatherstripping and press the weatherstripping firmly into the adhesive. Make sure the entire length of weatherstripping seats well into the adhesive. Let it set for the required time on the adhesive bottle, then close the doors and trunk onto the weatherstripping to seal it completely.
the weather stripping is bad
Replace the fuel filter. This fixed the same problem on my 1983 300 turbo diesel.
Yes, But Can I now What MB you have.
To replace a spring loaded MB rear view mirror first press in the spring and remove the old mirror. Next, get one end of the spring-clip on the new mirror in place and hit with a rubber mallet to snap the other end in place.
The sending unit in the fuel tank is defective,, replace it and fix your problem.
I want to now how i can replace the water pump in my e320 mb 1994
I need to replace the front disk pads on my 1996 MB E300
http://202tech.mkosonen.com/howto/blower.html detailed and illustrated how to with no need to visit MB stealership
To replace the ignition switch on a 2001 MB C240, first disconnect the battery to ensure safety. Remove the steering column covers by unscrewing the necessary screws, then locate the ignition switch, which is typically mounted near the ignition lock cylinder. Disconnect the wiring harness and unscrew the ignition switch from its mount. Replace it with the new switch, reattach the wiring, and reassemble the steering column covers before reconnecting the battery.
Sorry here is a better answer: Single-sided, 8 sectors/track: 160 KB (1981) Single-sided, 9 sectors/track: 180 KB (1983) Double-sided: 360 KB (1983) High-Density: 1.2 MB (1984)
There is more than one type of A57 if it is the full size tower then it's ATX. The other type is known as SFF Small Form Factor (Is the PC really slim) if that's the case it will be a little harder to find a MB that will fit.
The single bulb that lights up all three climate dials on my 2000 MB ML320 is out. Can it be removed or is it LED is there a special tool?