Dealer device required for programming. No cloning availiable.
----------
2003 X-Type Results are below. Maybe other Jaguar year models require dealer to reprogram.
After changing the batteries on the keys, the remote stopped working. I have two 2003 X-Type Jaguars and the below steps worked and I confirmed it on both my Jagaurs. You have to be fast for step 2.
1. Open the driver side door.
2. Turn the ignition switch to the 'auxiliary' position, then turn the ignition switch to the 'ON' position and back to the 'auxiliary' position four times. *This must be done fairly quickly. If you have done it correctly, you will hear a chime come from the GEM*
3. Turn the ignition switch to 'OFF' position.
4. Remove the key from the ignition.
5. To program the transmitter, press any key within ten seconds. **If it worked, you should hear another chime come from the GEM**
6 . Close the door...YOUR DONE! 7 make sure you do all your transmitters at the same time
Programing a remote key on a jaguar s type has to be done by a jaguar service center. Only authorized technicians should do it because often, people end up spoiling the remote system when they program it on their own.
A Toyota Matrix transponder key is factory programed. At times this programing can fail. It is a quick process for the dealership to reprogram the key. A lost key and transponder will cost approximately $100 to replace depending on model.
no
The ignition key has a transponder in it. Without the dealer programming the transponder, the key will not start the car. You can get a key made at your local Jaguar dealership for about $85 including the necessary programming. Some automotive locksmiths provide this service. I am an automotive locksmith and I cut and program the keys that you speak of.
To reprogram the transponder on a 2003 Mercury Sable, you'll need a working key and the vehicle's ignition system. Start by inserting the working key into the ignition and turning it to the "On" position without starting the engine. After about 10 minutes, turn the key back to the "Off" position and repeat this process two more times. On the third cycle, turn the key to the "On" position and then quickly insert the new key within 10 seconds to program it.
I don't program your transponder key. Try taking it back to a garage of the same type as your car e.g ford and they may be able to provide some help.
Locksmiths have transponder detectors that read if a transponder is active within a key. The device we have is called "TD3AII Transponder Detector" by Ilco.
Most General Motors built cars are now using the PK3 Transponder key.
Car Key
It can cost as much as about 300 dollars to re-key the average car. This varies depending on the type of ignition and the type of key.
programming can only be done at the dealer and some locksmith .programming require certain unit to communicate with the vehicle
ignition key replacement ignition key programming transponder key replacement transponder key programming car key remote replacement car key fob programming