0
Put the driver's window down, lift the bonnet and ensure all equipment is switched off.
Ensure all doors are closed and remove key from the ignition.
Wait for 3 minutes, disconnect the vehicle battery and wait 15 seconds.
Reconnect the vehicle battery, wait a further 10 seconds (do not open doors.).
Switch on the side lights through the driver's window.
Switch on the ignition and check system's functionality.
Hold lock button on key down for 10 seconds.
Remove key open & close door test central locking system.
Start the engine and complete the system's check.
Failure to follow this procedure could result in incorrect operation of many BSI related items
What else can I help you with?
How do you reset the service indicator in a peugeot 407?
It should say in your handbook.
How do you wire in a two socket tow bar to a Peugeot 407 SW LOOM?
You need a peugeot kit, that includes a new ECU. This then needs coding into the vehicles BSI, which can only be done by a dealer.
Peugeot 407 towbar wiring?
nightmare, you have to use a peugeot kit that gives an extra control unit, that then has to be programmed to the vehicles BSI.
Reset particulate filter warning on peugeot 407?
Dealer only im afraid
Reset fob Peugeot 407?
you need a key code, and even then it can only be coded by an authorised dealer
Where is fuse for brake light for Peugeot 407?
where is the fuses for a peugeot 407
How do you replace Peugeot 407 serpentine belt?
How do you replace peugeot 407 serprntine belt
Where is the bsi unit in a Peugeot 306?
central look doors
Where is the bsi unit on a peugeot 307 sw?
The BSI unit is the componant that the fuses are plugged into. It is in the glove box on the passenger side of the car.
When do you change timing belt on a Peugeot 407 hdi 16 valve?
when to chang timing belt on peugeot 407 hdi 1.6
How do you reprogram a lost keyfob for a Peugeot 407 sw 2007?
Procedure to reprogram a lost keyfob for a Peugeot 407 sw 2007
How do you reset tire pressure sensors on Peugeot 407?
You need to go under your vehicle settings. Once in the flat tire monitor, you can select reset. It may that you have a small leak which is why the light is still on.
