Look under the passenger seat. You'll find a connector for the airbag. Clean this connector or at least check if the wires are connected properly...
To reset the airbag light on a Renault Clio, first ensure that the ignition is turned off. Then, disconnect the car battery and wait for about 10-15 minutes to allow the system to reset. Reconnect the battery, turn on the ignition, and check if the airbag light is off. If the light persists, it may indicate a deeper issue that requires a diagnostic scan.
service light and abs light on my clio 172 sport how do i reset thanks
How do you reset the service light on a 2001 Renault Clio?" and can you take your seat out and take the air bags out and how is it done
To reset the service and airbag lights in a Renault Clio Privilege, you typically need to turn the ignition to the "On" position without starting the engine. Then, press the gas pedal three times within a few seconds. For the airbag light, if it remains lit after this process, it's advisable to use a diagnostic tool to check for any underlying issues, as it may indicate a fault that needs addressing. Always consult your vehicle's manual for specific instructions related to your model.
The process of reseting the abs light on Renault clio is a really easy process. Simply hit the "reset" button on your Renault Clio to restore your machine to its original factory settings.
alright m8 if u pull the ash tray out u will se it under ther. do u know ow 2 reset the service and airbag light ???
You put your seatbelt on.
depends which lights you mean there is a immobilizer light a injector light a glowplug light a engine management light a airbag light abs light reply with which light and I'll explain it for you
The serv light means that there is a problem with the ecu,u will have to take it to a garage to get looked at
Put some oil in the engine. This warning light means your oil level is low.
To reset the engine management light on a 2003 Renault Clio, you can use an OBD-II scanner to clear any diagnostic trouble codes (DTCs) that triggered the light. Alternatively, you can disconnect the car battery for about 15 minutes to reset the system, but this method may also reset other settings. Always ensure that any underlying issues are addressed before resetting the light to avoid future problems.
To reset the spanner light on a Renault Clio, first turn on the ignition without starting the engine. Then, press the accelerator pedal fully three times within five seconds. After this, turn off the ignition and start the engine to verify that the spanner light has been reset. If it remains on, the procedure may need to be repeated or there may be an underlying issue that requires attention.