Remove the Fuse for Fuel Injection for a few seconds. The fuses are located under the cover in the centre of the dash. The Release for the cover is just under the trailing edge, above the radio/heater controls, of the cover. On my '95 the fuel injector/EMC (computer) fuse is near the right rear of fuse area. Note: There's a nice diagram on the underside of the dash cover panel that you just removed.
You will need to go to a repair shop and have them scan for codes. That will tell them the problem and when it is repaired they can reset the light.
To reset the check engine light on a 1991 Toyota Previa, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the engine codes and reset the light. Alternatively, if you have access to an OBD-I scanner, you can use it to clear the codes directly. Make sure to address any underlying issues that caused the light to activate before resetting.
Remove the engine fuse for 10 seconds and put them back simple
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
hoe do you reset the check engine light in a 1995 land rover
how do i reset the check engine light on a 1999 acura 3.2tl
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?