answersLogoWhite

0

RESETTING OIL SERVICE INDICATOR:

If your OBC needs to be reset after completing your oil change, there are two ways. NOTE: If you miss a step, just turn the key back off and try again:

A. Model Year 1999 to Mid-2000: You should have the older round 20-pin DLC connector under your hood behind the battery terminal, you need to use a small length of wire to connect (short) pins 7 and 19 for 3-5 seconds with the ignition key in position 1 (Accessory).

B. After Mid-2000: You should not have the 20-pin DLC connector. You only need to hold the left odometer reset button while turning the key to position 1 (Accessory). Keep holding the button for 5 or so seconds until any of the following shows in the display: OIL SERVICE or INSPECTION with RESET or RE. Release the button and press it again for another 5 or so seconds until RESET or RE flash. While the display flashes, press the button one more time briefly. If done correctly, END SIA should show up for a few seconds. All done.!

hope this helps :) Know can anyone help me and tell me how to reset the airbag light on a 99 e46??

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Reset service engine soon light on 2000 Nissan?

How does one reset service engine light on 2000 Nissan Quest Thanks Bill


How do you manually reset the service engine soon light on a 2000 BMW Z3?

To manually reset the service engine soon light on a 2000 BMW Z3, you can use the following steps: First, turn the ignition key to the "On" position without starting the engine. Then, press the gas pedal fully three times within five seconds. Finally, turn the ignition off, and the light should be reset when you start the vehicle again. If the light stays on, there may be an underlying issue that needs to be addressed.


Where is the reset switch located for the service AWD light on a 2000 Olds Bravada?

no reset switch in this system


Airbag light reset 2000 Volvo s80?

In order to get your SRS Service Airbag light reset, You have to go to the Volvo dealership.


How do you reset the service light on a 2000 reg Megan?

In order to reset the service light on a 2000 reg Megan you\'ll need to start by turning the ignition switch to the "On" position without starting the engine. Once the service light appears on the dashboard you can reset it by following these steps: Press and hold the odometer reset button Turn the ignition switch to the "Off" position Release the odometer reset button Turn the ignition switch back to the "On" positionAfter following these steps the service light should reset and no longer appear on the dashboard.


How to turnoff Reset butter for Service Engine Soon light 2000 F150 ford?

2000 F150 Harley-Davidson


How do you reset the service light of a 2000 Honda Accord?

Under the hood on the drivers side, there is a main electrical box. There should be a reset botton there.


How do you reset the service engine soon light on a 2000 Bonneville?

put tape over lite jtyj


How do you reset service engine soon light for a 2000 Chevy Suburban?

That requires an OBDII engine scanner.


How do you reset the performing service light indicator on a 2000 Jeep Cherokee?

Key on, close doors. Press "step" until "0 miles to service" is displayed. Press and hold "reset".


Reset abs light 2000 Yukon?

how to reset abs warning light on 2000 gmc Yukon


How do you turn off the perform service light on a 2000 jeep grand Cherokee?

you reset it by hitting step until you see "miles remaining to service" then you hold reset button and it will change to 3000