With ignition off, hold right (trip reset) button
Turn ignition on
Still holding trip button turn left (clock) button to minutes (clockwise)
Release everything and turn off
To reset the service indicator on a VW Polo, turn on the ignition without starting the engine. Press the gas pedal three times within 10 seconds. After that, turn off the ignition and start the engine to confirm that the service indicator has been reset. If it doesn’t reset, repeat the procedure.
The ABS indicator stands for the Automatic Brake System indicator. It can be reset by restarting the entire control display.
When your car is serviced at a non-vw garage or at home by yourslef, the ecu doesnt know its had a service, so the service indicator stays on. To reset it: -(with the ignition off and keys out) press and hold the mile reset button -turn ignition on -wait until the display goes like '--' -turn ignition off and keys out and release button
ALL MODELS OF VW SERVICE WARNING INDICATORS CAN BE RESET BY YOURSELF WITH NO TOOLS, DONT PAY SILLY DEALER PRICES..... LINK TO MY EBAY PAGE FOR MORE DETAILS http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=200289233339&ssPageName=STRK:MESE:IT&ih=010
CHECK
servis ansp vw 98
Volkswagen Caddy was created in 1980.
Found this on the vw t4 forum, it's great for any query you have with regards to T4's "with the ignition turned off, u press and hold the mileage reset button.next, with the button still pressed, turn the ignition 2 clicks (but dont start).release the mileage trip button, and turn the clock button clockwise which should reset the "service" indicator. if not thrash the dash with a large scafold tube, then i"tll go off!!!"
A bad ABS module will make your traction light stay on in your VW Caddy.
Yes (tell if not answer)
To reset the service reminder on a 2006 VW Polo 1.6, first turn on the ignition without starting the engine. Press the trip reset button on the dashboard until the mileage display shows "Service." Then, hold the button down for about 10 seconds until the service indicator resets. Finally, turn off the ignition to complete the process.
First, turn on ignition and hold down right trip button while turning off ignition. Then, turn ignition back on and release right trip button. And then, turn left trip button to the right and release. Finally, turn off ignition. Service indicator should be reset when you next start the vehicle.