reconnect the sensor at the back of the disc caliper.One of them has come off-just press back on
Low brake fluid.
...I have the exact same problem with my 1993 corolla.......Brake System warning light and discharge warning light
change ur brake pads?
Turning off the airbag warning light on a vehicle is unsafe. The light is on for a reason, either a bad sensor, or an issue with the airbag. Either way, you should bring this in to a mechanic to have it looked at.
the switch on brake pedal is faulty and needs replacing
There is a sensor in the top of the brake cylinder where you put in the fluid. Replace it and the light will go away.
somtimes float sticks down in brake master
Remove the cover from your third brake light. Take hold of the lightbulb, push in and turn at the same time. The lightbulb will come out.
the only way you change brake pad or disc
There is an electircal switch that 'senses' when the emergency brake lever is applied and lights a warning light on the dashboard to keep you from driving in this condition. This switch may be faulty or out of adjustment, causing the warning light on the dashboard to turn on.
To turn off the airbag warning light on a 2000 Vectra C, first ensure that all airbag connections and sensors are intact and functioning properly. If there are no issues, you can use an OBD-II scanner to reset the airbag system. Alternatively, disconnect the car battery for about 10 minutes, then reconnect it, which may also reset the light. If the warning persists, it’s advisable to consult a professional mechanic for further diagnostics.
To reset the brake warning light on a Porsche 928, first check and ensure that the brake fluid level is adequate and that the brake system is functioning properly. If the fluid level is correct and there are no issues, turn the ignition to the "on" position without starting the engine. Then, press the brake pedal several times; this should reset the warning light. If the light remains on, it may indicate a deeper issue that requires professional diagnosis.