Key off
Press and hold clock button on dash
turn key to on positions (do not start car) and wait 10 seconds
turn off key and release button
Start car ... indicator should be reset.
How do you turn off airbag in vw polo 1999
To reset the service inspection on a VW Polo, turn on the ignition without starting the engine. Press the accelerator pedal three times within 10 seconds, then turn off the ignition. When you restart the car, the service indicator should be reset. If it doesn't reset, you may need to consult the owner's manual or a professional for assistance.
To turn off the inspection light on a 2005 Volkswagen Polo, you typically need to reset the service indicator through the vehicle's dashboard. Start by turning the ignition key to the "on" position without starting the engine. Then, press the accelerator pedal three times while holding down the trip reset button. This should reset the inspection light. If the light remains, consult your owner's manual for specific instructions or consider a visit to a mechanic.
No
if its a new polo then they wont turn off fully
To reset the service light on a 1999 Volkswagen Polo, turn the ignition key to the "on" position without starting the engine. Press the gas pedal three times within five seconds. After this, turn the ignition off and then start the engine to confirm that the service light has been reset. If the light remains on, you may need to repeat the process.
I turn it off to go shopping then will not start again
To turn off inspection light on a 2005 Holden Barina, press down the trip reset. Then place the key into the ignition and turn to first stop while holding down reset for 10 seconds.?æ
To turn off the 1999 Jaguar S_type safe mode simply check your user manual.
change ur brake pads?
To turn off the safe mode on a 1999 Jaguar S-type, simply refer to your user manual.
To turn off the check engine light on a 1999 Acura RL 3.5, first, you should diagnose the underlying issue using an OBD-II scanner to read any trouble codes. Once the problem is resolved, you can reset the light by disconnecting the negative battery terminal for about 10-15 minutes. Reconnecting the terminal should turn off the light. If the light persists, it may indicate an unresolved issue that needs further inspection.