0
To turn the lever you can use a 1/4" drive ratchet, a 4-6" extension bar, and a 5mm socket. Alternately you could use a nutdriver with the same 5mm socket as long as the shaft is long enough to provide clearance for your hand. Turn the lever counter-clockwise 180 degrees to free the headlight housing. Use a long screwdriver, about 12" shaft, or a similarly long stick or other object to push down on the aluminum catch located behind the headlight housing. This catch can be seen by looking in the void immediately behind the battery box at the back of the headlight housing. It is a rectangular catch that will easily release when you press down. The headlight housing will then slide out of the front of the car by pushing from inside the engine compartment. Do not let it slide out and hit the ground. Slide it slightly forward and then stand in front and pull it the rest of the way out. Tools needed: 1/4" drive ratchet 6" or longer extension bar for the 1/4" drive ratchet 5 mm socket 12" or longer screwdriver, stick, or similar object alternately: 5 mm nutdriver with 6-8" shaft
What else can I help you with?
How do you replace headlight for 2008 Hyundai Sonata?
The headlight on your 2008 Hyundai can be removed by removing the headlight retaining bolts from the inside of the engine compartment. Remove the wiring harness and replace with a new headlight.
How do you replace headlight bulb 2008 JK Wrangler?
Page 405 in your owner's manual.
How do you replace the headlight bulb on 2008 Chevy Malibu?
Pull the complete headlight assembly out to get to the bulbs. You first have to pull the front bumper off, along with the wheel well to get to the headlight assembly.
How do you replace the headlight bulb on a 2008 Subaru Legacy Outback?
See "Headlight" on page 52 of chapter 11 "Maintenance and Service" in your "OWNER'S MANUAL".....
How do you replace headlight on 2008 Hyundai Elantra?
Open your hood and remove the 2 push pins that connect the engine compartment plastic separator. There are also 2 bolts to remove and then you can pull the headlight from the frame. Replace the bulb and put the headlight back.
How do you replace Headlight bulb 2008 Ford Focus?
To replace the headlight bulb on a 2008 Ford Focus, first, ensure the vehicle is off and the keys are removed. Open the hood and locate the back of the headlight assembly. Disconnect the electrical connector, then twist the old bulb counterclockwise to remove it. Insert the new bulb by twisting it clockwise, reconnect the electrical connector, and test the headlight before closing the hood.
How do you replace the headlight bulb on a 2008 Jeep Wrangler?
To replace the headlight bulb on a 2008 Jeep Wrangler, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the back of the headlight assembly; twist the bulb socket counterclockwise to remove it. Disconnect the old bulb by pulling it straight out, then insert the new bulb without touching the glass. Finally, reinsert the socket into the headlight assembly and twist it clockwise to secure it.
Oil change on a 2008 VW Beetle?
where is the oil filter on a 2008 vw beetle
Headlight replacement on 2008 ford f-550 super duty?
There is lots of space to replace the headlight just unscrew the bolts i think its 2 of them and there is a plastic clip that usually holds them in.
How do you remove the headlight switch on 2008 f-250 ford?
Remove the knobs, remove the dash panel, and replace the switch.
How do you replace a headlight bulb on a 2008 Malibu?
Remove tire & inner liner to gain access to head light assembly
How do you replace a headlight bulb on a 2008 Acura MDX?
To replace a headlight bulb on a 2008 Acura MDX, first, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector by gently pulling it away from the bulb. Remove the rubber cover, then twist the old bulb counterclockwise to release it. Insert the new bulb, making sure not to touch the glass with your fingers, and reverse the steps to reassemble.
