empty your center consol and remove the screws in the bottom an lift it out. Then believe it or not the swith assembly comes up. Be carful to not break any of the tabs.
Take it to the dealer.
Their is no relay. Power goes through the switch strait to the window motor.
Yes
how to repair a window motor on a 380sl mercedes
A power window relay switch relays the power from the car's battery, to the switch itself, and then to the window motor. When pressing the button inside of the car it allows the power to go from the relay switch to the motor and roll the window up or down.
If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.
The most common window problems in a 2007 Sebring are the fuse, the relay, the switch, and the motor. Check the fuse and the relay. If they are ok then the door will have to have the panel removed to reach the switch and motor.
the switch is on the door panel approx four inches from the window, this is the only switch that sends power to the window regulator motor (window motor).
Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.
If it looks the same it will probably work.
NOTE: Anytime the battery terminal has been disconnected, please initialize the driver's door power window and front passenger's door power window after reconnecting the battery terminal. With ignition switch in the "ON" position, do the following: 1. Push down and hold the driver's door power window switch to completely open the window. 2. Pull and hold up the driver's door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination. 3. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions. At this time the power window switch for the passenger's door window should be blinking. 4. Push down and hold the passenger's door power window switch to completely open the window. 5. Pull and hold up the passenger's door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination. 6. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions
The led light in the window switch is not replaceable. It is only serviced with the entire switch.