All you have to do is remove the trim piece from around the assembly. This will allow you access to the screws holding the switch in. Remove the screws, unplug the switch and take it out. Put the new one in.
.41 is the gap specified by the Haynes manual for the 1990 Geo Prizm.
When 1990 Honda is running cooling fan does not come on but comes on when engine is off and I thermostat and temperature switch changed?"
where is the vacuum diagram located on 1995 geo prizm
Check to see if you are getting power to blower motor--if so, bad blower motor If no power- perhaps bad resistor pack at blower motor Bad switch?
what transmission will fit in a 3 speed 1990 geo prizm
yes but do check first because a 1990 Geo prizm is basically a re branded version of a 1990 Toyota corolla.
Blower resistor must not be functioning properly. It should be replaced
If the blower in a 1990 Ford Bronco won't come on, it could be due to several issues. Common causes include a blown fuse, a faulty blower motor resistor, or a malfunctioning blower motor itself. Additionally, check the wiring for any damage or loose connections. If these components are functioning properly, the issue may lie within the switch or climate control system.
the fan blower relay is located in the front left hand side looking at the car. right behind the headlight. there are 4 relays there. it is the one on the far right. I just replaced it.
Ther are three different engine configurations used on the 1990 prizm. Check a repair manual such as Haynes. If you plan on keeping the car for a long time a manual would be a good investment.
More than likely a bad switch.
There is a tail light switch located at the top of the pedal mechanism. It's a small part with one small bolt that hold it on. Pull and replace it. You may need to adjust the travel of the switch's piston for proper operation. Simple job.