Hi There, it depends how you use your clutch,
Most people damage their clutch because of incorrect use of clutch.
Always make sure when you apply brakes you press the bake pedal only, therefore be fore the rev counter reaches 10 then you can press your clutch pedal. That will assist your engine to slow smoothly, just imagine pressing half clutch and hald break, the friction between your clutch plate and engine increases because the engine speed is still high, Just imagine doing that while you are doing 120Km/h,
To be honest it's a long process and most of the time requires you to take out the car engine. Not for amateurs!
Changing a VW Polo clutch cable requires exposing both ends of the cable. An open ended wrench will be needed to loosed the existing cable. After replacing the cable, be sure to bleed the line to prevent failure.
straight from the dealer u are looking at plus/minus R15000
On a 1997 VW Polo 1.0, the clutch is located on the left side of the driver's footwell, operated by a pedal. The clutch assembly itself is situated inside the engine compartment, mounted on the transmission. To access it for maintenance or replacement, the gearbox typically needs to be removed. Always consult the vehicle's service manual for specific guidance and safety precautions.
Yes, you can adjust the clutch on a VW Polo from the S registration, but the process depends on the specific transmission type. If it's equipped with a cable-operated clutch, you can adjust the clutch cable tension at the adjustment point near the pedal or at the clutch fork. However, if it has a hydraulic clutch system, adjustment is typically not possible, and you might need to check for other issues like fluid levels or master/slave cylinder function. Always refer to the vehicle's service manual for detailed instructions.
To change the clutch cable on a 1998 VW Polo, first, secure the vehicle and lift it if necessary. Begin by disconnecting the battery and then remove the old clutch cable from the pedal assembly inside the car and from the clutch release mechanism on the transmission. Install the new cable by threading it through the same pathways, ensuring it is properly adjusted and secured at both ends. Finally, reconnect the battery and test the clutch operation before lowering the vehicle.
New VW Polo for EU market is made in Bratislava, Slovakia.
How do you turn off airbag in vw polo 1999
Can someone advise how i fit an elecrtric pump to a vw polo twist?
1.4liter polo Playa 2002
It does.
Spain