0
What else can I help you with?
How does the brake wear light on the dash 1999 Porsche Boxster get reset?
To reset the brake wear light on a 1999 Porsche Boxster, first ensure that the brake pads have been replaced and the wear sensors are properly connected. Then, turn the ignition key to the "On" position without starting the engine. Press the brake pedal several times to allow the system to recognize the new sensors. Finally, turn off the ignition and start the engine to confirm that the brake wear light has been reset.
How do you replace the headlight bulb on a 1999 Porsche boxster?
To replace the headlight bulb on a 1999 Porsche Boxster you will need to open the trunk and take out the screw of the spare tire compartment. Slide the entire headlight assembly out after loosening it with a hex socket wrench. Then, put a new bulb in place.
What is the number of the Porsche in Gone in 60 Seconds?
There are several Porsches in the remake of Gone In 60 Seconds: 1988 Porsche 959, 1999 Porsche 996, 2000 Porsche Boxster, 1961 Porsche Speedster. In the original film the Porsche stolen from an auto dealership is a Porsche 911.
What is the TCM on a 1999 Kia Sephia and how does it affects oxygen sensors?
The TCM is the transmission control module and it has nothing to do with oxygen sensors!
How do you open trunk for 1999 Porsche boxster if trunk release cable is broke and key is in trunk?
dealers can do it - they have a way to get in from the engine compartment but won't share how it is done :(
How many o2 sensors does a 1999 ford ranger xlt have?
That Vehicle has 2 oxygen sensors.
Where is the 1999 Porsche boxster airbag fuse?
The airbag fuse for a 1999 Porsche Boxster is located in the fuse box, which is found in the front luggage compartment. Specifically, you can find it in the left side of the fuse panel. Look for a fuse labeled for the airbag system; it typically has a specific amperage indicated on the cover of the fuse box. Always consult the owner's manual for precise details on fuse location and specifications.
What is torque for oil filter on 1999 Porsche boxster?
The recommended torque for the oil filter on a 1999 Porsche Boxster is typically around 25 Nm (18.5 lb-ft). It's important to ensure that the oil filter is tightened securely but not overly tight, as this can lead to damage or difficulty during future removal. Always refer to the owner's manual or a service manual for the most accurate specifications.
How do you remove the stereo from the 1999 Porsche boxster?
To remove the stereo from a 1999 Porsche Boxster, first, disconnect the car battery to ensure safety. Then, use a trim removal tool to carefully pry off the trim surrounding the stereo. Next, remove the screws securing the stereo in place, and gently pull the unit out. Finally, disconnect the wiring harness and antenna cable from the back of the stereo to complete the removal.
How many oxygen sensors on 1999 Mercury Sable?
Four
How many oxygen sensors are on a 1999 Toyota Tacoma?
2
Where are the oxygen sensors located on a 1999 camaro?
Exhaust system.
