To reset the Insignia's INS2 (service interval) on a Corsa D, turn the ignition on without starting the engine. Press the accelerator pedal fully three times within 10 seconds. Then turn the ignition off, and the service light should be reset. If the light remains, repeat the process.
It should reset right away.
You have a bulb out...
sorry it's an Opel zafira o6 wouldn't start and when it did this came up
sorry it's an opel zafira o6 wouldn't start and when it did this came up
To reset the computer box (ECU) of an Opel Corsa 1.6 GSI, you can disconnect the negative terminal of the car battery and leave it disconnected for about 15-30 minutes. This will allow the ECU to reset itself. After reconnecting the battery, start the vehicle and allow it to idle for a few minutes to let the ECU recalibrate. Always ensure you have any necessary radio codes or settings backed up before performing this reset.
hold down the mileage reset then turn ignition on and until the InsP turns to ---- let the reset go and walla you can start the car or turn the ignition off This works on my Corsa, think the same instrument panel is in the astra Not sure if anyone knows but you can reset your service inspection lamp on your Vectra C, Astra H and Corsa C & D with out the aid of any diagnostic tools. Simply press the trip reset button on the dash at the same time press the brake pedal then switch on the ignition, keep brake and trip pressed for 10 to 12 seconds and hey presto its done!! If you already knew that i will go back and crawl into my shell
To reset the service light on a 2007 Vauxhall Corsa, turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds. Turn the ignition off, then turn it back on to check if the service light has reset. If the light remains, repeat the process or consult the vehicle manual for specific instructions.
Bigends and main torque and cylinder head torque Opel corsa d 2009 1.4i 16v CZF729
yes
To reset Corsa D 57 plate do the following, put your foot on the brake pedal then press and hold the odometer button in. Wait until Insp 0 comes on the display, then switch on the ignition wait a few seconds. Now it should display Insp 19000 (depending on service interval). Release button and brake pedal, now switch off ignition. Next time you turn on ignition the Insp 0 should no longer show on the display. This did work for me.
D you want them in the doors or on the real quarters or the back panel?
Coesa B