the easiest thing to do is remove the slave cylinder then pump the pedal and the fluid will pour out
The Hydraulic clutch fitted to the rover 400 is a sealed unit and the only thing that you can do is to replace the complete unit
To bleed the clutch of a Rover 75, first remove the interior panels on the steering column. Second, remove the master cylinder and use a syringe to inject the fluid into the system and repeat 4 times to bleed the clutch.
its hydraulic not cable
you can adjust the clutch cable as it is a hydraulic clutch, only option is to change the clutch if it is worn or slipping.
To bleed the clutch in a Rover 400, start by locating the clutch slave cylinder, typically found on the transmission. Use a wrench to open the bleed screw slightly while an assistant presses the clutch pedal down. Close the bleed screw before the pedal is released to avoid drawing air back into the system. Repeat this process until no air bubbles appear in the fluid, ensuring the clutch operates smoothly.
How do you bleed air from radiator of a 2000 range rover?
how to bleed fuel filter on land rover discovery 3
Yes
If no signs of leakage at slave operating cylinder,then check clutch master cylinder for leakage,and look at clutch pedal and see if you see any clutch fliud as rod comes thru firewall.follow all lines.
The clutch cable has proabably broken.
If it has a bleeder then you bleed it.
down by the clutch pedel, closer to the radio tbh,