IF YOUR TALKING ABOUT THE OVERHEAD DISPLAY. GET IT TO THE KILOMETER, THEN HOLD THE BOTTONS IN ON EACH SIDE OF THE PANNEL TILL IT BEEPS..
HOPE IT HELPS
By changing it to miles!
In a 2007 Jeep Grand Cherokee, the trip odometer is located on the instrument cluster, which is directly in front of the steering wheel. You can toggle between the trip odometer and the main odometer using the trip reset button, typically found on the dashboard or on the cluster itself. To reset the trip odometer, press and hold the button until the display resets to zero.
Because your odometer, or something connecting the odometer to the battery, is broken. Most likely the odometer is the problem if the rest of your dashboard is working fine.
It depends on whether or not the car has a digital readout. If it has a digital display, chances are it would be a wiring problem, somewhere right behind the odometer. If it has an analog display, since the spedometer still works, chances are the odometer itself (the display) has gone bad--like a little gear in there or something. This is one of the simplest odometer problems to fix; just replace the display piece. If the spedometer wasn't working it would be a whole different story--probably a faulty cable.
Put the key into the ignition and press the odometer button. While holding down the odometer button, turn the key to the on position. You will see "-----"on the odometer display. It will count down "-----" "----" "---" "- -" "-". Then you will see zeros on the odometer display "000000". You can now release the odometer button. This will reset the maintenance light on your dash!!!!!!
The odo doesn't display speed at all, only distances covered.
Celsius
Under the speedometer. Push the trip meter reset button and the display will change from outside temperature to the odometer.
With a scan tool, or by turning the key on, off, on, off, on and watching the odometer display.With a scan tool, or by turning the key on, off, on, off, on and watching the odometer display.
The best way to fix a radio and odometer display that doesn't work is to check the fuses. When you replace the bad fuse then the lights should work in your dash.
Press and hold in the odometer setting button till display shows miles or kilometers
Turn key to off-on-off-on-off-on within 5 seconds and watch the odometer. It will display all of the codes flash "end" at the completion. A 1993 will flash the check engine light in two digit code numbers. The odometer trick didn't start until about 2001.