Obviously it depends on whats broken...motor, switch, or very likely in these, the window regulator has a plastic part that snapps. Entire Regulator needs replacing. (The regulator is essentially the frame mechanisim that hold and moves the window glasss). Remove interior door panel to do so. Not terribly difficult, but playing around to get the new one to line up right can be tricky....till you get it.
you can't have to buy new
what is the average repair cost to fix an electric window switch motor 2003 jeep
How do yo fix a stuck driver side electric window on a 1998 pontiac firebird.
To fix a cable on an electric window on a 2004 Chevy Epica you need to first gain access to the wire by removing the door panel. From there, you can either fix or replace the cable.
If electric then possibly a window switch or motor. If mechanical possibly off track.
First you have to figure out if it a ad switch, bad regulator or bad electric motor. After proper diagnosis replace the part at fault.
To fix the window in a Mercedes CLS 500, first ensure the vehicle is off and disconnect the battery for safety. Remove the door panel by unscrewing any screws and carefully prying it away from the door frame. Inspect the window regulator and motor for damage; replace them if necessary. Reinstall the door panel, reconnect the battery, and test the window operation.
apparently the window motor is bad and will need replaced.
take it 2 a garage
my electric windows on my Cherokee jeep won`t work. WHAT can i do to solve this
To fix a rear window that is off track on a 2002 Mercedes Benz C320, you will first need to remove the interior door panel to access the window mechanism. Carefully inspect the window regulator and guide channels for any damage or obstructions. Realign the window within the tracks, ensuring it is seated correctly, and reattach any loose components. Finally, reassemble the door panel and test the window's operation.
The electric windows on a 406 might behave weird if you disconnect the battery. But holding down the "window-down" on drivers side for 10 seconds or so should fix it.