Correct tool to use Brake Caliper Piston Rewind Tool
A lot of pistons easily go back in using a lever or pair of large oil filter pliers just take care not to damage piston seals and not to damage the caliper surface.
change ur brake pads?
First step: start by finding the brakes on it...
How do you compress the rear brake caliper pistons to install new pads on vw polo 08 model?Read more: How_do_you_compress_the_rear_brake_caliper_pistons_to_install_new_pads_on_vw_polo_08_model
I had the same problem about a week ago. What you do is use a type of tool similar to the fastning key of a angle grinder.Place the tool(key) in the grooves of the piston and turn clock wise while someone pushes the piston back using a any type of device that will assist you in pushing hard enough while turning (Help will be needed). The piston will move back on turn remember to apply presure while turning. Another option is a G-clamp or similar with jaws wide enough to go on the piston and a secure point on the calliper. Winding in the clamp will slowly push the piston back in.
Simple. Use A Break Bar And 17mm Socket To Remove Wheels. Then To Loosen Caliper Bolts Use 7mm Allen Socket And Ratchet. Remove Caliper And Remove Old Pads. You May Need To Pry Them Out Due To Dirt, etc. Use A Wire Brush To Clean The Pad Carriers ( The Part That The Pads "Hooks" Sit On) Then Grease Slightly With Copper Grease. Put New Pads In Then Push The Piston On The Caliper Back Using A Set Of Pliers. Build It Back Up And Pump The Brake Pedal Before Driving. Source- VW Mechanic
Remove wheels Re-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body Replace pads inner and outer RE-Install caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
Take a photo of your front disc and pads.and ill be able to explain how.
To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.
How do I replace rear brakes on a VW Polo GTI
You will want to replace a brake light switch on a VW Polo professionally. You do not want to make a bigger situation than you already have. A mechanic will do the job correctly.
if the piston breaks that is engine damage.
An ABS light on the 2002 Volkswagen Polo refers to the assisted brake system. When the light shines it means there is something currently wrong with the brake system and should be serviced.