0
What else can I help you with?
How do you replace the serpentine belt on a 1997 Ford Thunderbird?
Remove your idler pulley first. it is the pulley right next to the alternator.
How do you replace a pulley on a 1993 Ford Taurus gl?
Which pulley?
Where does the trunk drain hoses go on a 1965 Ford Thunderbird?
How do you replace the trunk drain hoses on a 1965 thunderbird.
When do you replace a pulley in Ford Explorers?
When it goes bad
How do you take off the smog pump pulley on a 92 ford thunderbird 5.0?
To remove the smog pump pulley on a 1992 Ford Thunderbird 5.0, first, relieve the tension on the serpentine belt by using a wrench to turn the tensioner pulley. Next, use a socket and ratchet to remove the bolts securing the smog pump pulley to the pump. Once the bolts are removed, carefully pull the pulley off the smog pump shaft. Make sure to inspect the pulley and shaft for wear or damage before reassembly.
How do you unlock A Ford Thunderbird?
When i bought my thunderbird the key to the ignition didnt fit the door locks so i had to replace the locks. That might be the best answer. :]
How do you replace a starter for a 94 Ford Thunderbird?
go check in iraq, you commie. comprendo?
How do you replace the fuel pump on a 1992 ford thunderbird?
Remove fuel tank for access
How do you repair seatbelt on a 1990 Ford Thunderbird?
Dont repair...just replace it for your safety!
How do you replace the belt tensioner on a 3.8L Ford Thunderbird?
On my Taurus 3.0 engine, I used a wrench on the pulley bolt, and a pry bar to remove tension, allowing me to remove the belt. Then I used a star pattern socket to remove the nut.
How do you put freon in a 1994 Ford Thunderbird Lxcoupe?
1994 TBird has an R134 system. You can buy charge kits at any auto parts store. How do you put freon in a 1994 Ford Thunderbird Lx coupe so that the air conditioner can work?
How do you replace the serpentine belt on a 1989 Ford Thunderbird 3.8L?
you need a serpentine belt remover. Its $20 at autozone...The pulley on the bottom left will pull up if you use the tool..its the small pulley on the bottom left...very easy with the right tool....takes three hours without it:] and a lot of cussing...
