answersLogoWhite

0

underneath the centre console is a clamp in the clamp should be your 2 brake cables that control your handbrake ...you can tighten them there ...use spanner as is a squeeze to get a socket on

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you tighten handbrake Peugeot 406?

To tighten the handbrake on a Peugeot 406, start by locating the adjustment nut beneath the handbrake lever. Remove the center console cover if necessary to access it. Turn the nut clockwise to tighten the handbrake cable until you achieve the desired tension, ensuring the handbrake holds the vehicle securely. Finally, test the handbrake's effectiveness by pulling it up and ensuring it engages properly.


2004 Rav4 handbrake lever loose how do you tighten it?

its normally mechnical so find the steel cable and find the nut on the cable of the parking brake "handbrake" and tighten


How do you adjust the back brake on a ford fiesta zetec?

Remove handbrake gator and tighten exposed nut at the end of the handbrake.


How do you tighten the hand brake on vauxhall astra 1.7TDI?

To tighten the handbrake on a Vauxhall Astra 1.7 TDI, first, ensure the vehicle is on a level surface and securely parked. Locate the handbrake adjustment nut, typically found under the center console or near the base of the handbrake lever. Turn the adjustment nut clockwise to tighten the handbrake, checking the tension periodically by pulling the lever to ensure it engages securely after a few clicks. Once adjusted, test the handbrake by attempting to roll the vehicle slightly to confirm it holds effectively.


How do you tighten a handbrake on saxo?

On a Saxo, the handbrake can sometimes come loose and needs to be tightened. To do so, first turn the engine on and place your foot on the brake. Push in the handbrake button and then pull up on the handbrake until tension is felt. Repeat as needed.


How do you tighten handbrake on astra mark 4?

To tighten the handbrake on a Vauxhall Astra Mark 4, first, locate the handbrake adjustment nut, which is typically found under the center console or near the base of the handbrake lever. Use a socket or wrench to turn the nut clockwise to increase tension on the cable. Ensure the handbrake engages properly and check the lever's travel to confirm it's adjusted correctly. Finally, test the handbrake while parked to ensure it holds the vehicle securely.


How do you tighten handbrake on Daewoo 1.5?

Directly under the car, in line with the exhaust tubing. : )


How do you tighten handbrake golf mk4 gti?

Remove side covers on rear ashtray and lift out unit. The adjustment nut needs a 10mm spanner. Just about take up any slack when handbrake is off. Don't over tighten.


How do you tighten the handbrake cable on a fiat bravo?

There is a screw on the hand brake handle inside the cabin. Just take off the leather that is covering your handbrake lever, and you will see it.


How do you adjust 1993 Nissan Micra handbrake?

Put the handbrake on and lift the rubber flap up just below the lever. Beneath that will be a 10mm nut, tighten that to adjust handbrake. 1993 micra should be about 5-7 clicks


How do you tighten the handbrake on Hyundai accent 2002?

If the rear brakes are out of adjustment,the hand brake will not work..


How do you adjust the handbrake on a Hyundai coupe?

To adjust the handbrake on a Hyundai Coupe, first, ensure the vehicle is on a level surface and the handbrake is fully engaged. Locate the adjustment nut, usually found between the center console and the handbrake lever. Use a wrench to turn the nut clockwise to tighten or counterclockwise to loosen the handbrake tension. After adjustment, test the handbrake to ensure it holds the vehicle securely when pulled.