there is no button or switch. there is a gas door lock that is incorporated into the central locking unit on your car. it locks when you lock the car and unlocks when you unlock the car.
You can locate the main light control switch located on a 1989 Dakota by looking at the user manual.
It seems that it's not getting fuel and I can't hear the fuel pump running "Where is the fuel switch location in a 1989 300SE Mercedes Benz?"
Hazard lights.
If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
Yes. The inertia switch is located in the trunk on the drivers side (up near the trunk hinge) There will be a small white button to reset it.
To remove the ignition switch on a 1989 Toyota pickup, first disconnect the battery to ensure safety. Then, remove the steering column cover by unscrewing the screws that hold it in place. Next, locate the ignition switch assembly, disconnect the wiring harness, and unscrew the switch from its mounting position. Finally, pull the ignition switch out and replace it if necessary.
To remove the ignition switch from a 1989 Cadillac Eldorado, first disconnect the negative battery cable to prevent electrical shorts. Then, remove the steering column cover by unscrewing the screws, and locate the ignition switch. Disconnect the wiring harness from the switch, then remove the retaining screws or bolts securing the switch to the steering column. Finally, carefully pull the ignition switch out of its housing.
Yes , if the button on top of the fuel pump inertia switch ( shut off switch ) has popped UP , then no power is going to the electric fuel pump
First locate the inertia switch. On a sedan it is on the right side of trunk behind liner. On a station wagon - behind service panel on the right side of the cargo area.Push the red button down until you hear a click. If it doesn't click, the switch wasn't tripped in the first place and the problem is somewhere else.
Turn the brightness control up. Could be the reset button for the odometer or another switch.
To set the clock on a 1989 Cadillac Brougham, first turn the ignition to the "On" position. Locate the clock setting button, usually found on the dashboard or near the radio. Press and hold the "H" button to set the hour, and use the "M" button to adjust the minutes. Release the buttons once the desired time is displayed.
where to find electrical diagrams for starting system on mercedes 300sel 1989